paper

Measurement of mobility in dual-gated MoS2 transistors

arXiv:1301.4288 · doi:10.1038/nnano.2013.30

Abstract

Atomically thin semiconducting MoS2 is of great interest for high-performance flexible electronic and optoelectronic devices. Initial measurements using back-gated field-effect transistor (FET) structures on SiO2 yielded mobility of 1-50 cm^2/Vs for few-layer MoS2[1, 2]. Initial measurements using back-gated field-effect transistor (FET) structures on SiO2 yielded mobility of 1-50 cm^2/Vs for few-layer MoS2[1, 2]. However, greatly increased mobility - as high as 900 cm^2/Vs - was recently reported for monolayer MoS2 by Radisavljevic, et al.[Ref. 3; see also Refs. 4-6], and for multilayer MoS2 by others[7, 8], in devices covered by a high-kappa dielectric layer and a metal top gate. Similar increases were reported for electrolyte top-gated MoS2[9]. A puzzling common aspect of these reports is that the double-gated devices consistently show much higher mobility when measured using the weakly-coupled back gate (typically 300 nm of SiO2) than using the strongly-coupled top gate. While this difference might be attributed to a different quality of the top and bottom surfaces, the large discrepancy motivates close examination of the measurement techniques to rule out spurious effects. Notably, it has been shown that the mobility may be greatly overestimated in this geometry[10, 11]. There is good evidence that this is the case here[4-9]; below we discuss Radisavljevic, et al.[4] as an illustrative example.

Submitted as correspondence to Nature Nanotechnology

References in corpus (3)

Cited by in corpus (55)