Tuning carrier type and density in Bi2Se3 by Ca-doping
arXiv:1007.0470 · doi:10.1063/1.3473778
Abstract
The carrier type and density in Bi2Se3 single crystals are systematically tuned by introducing a calcium (Ca) dopant. A carrier density of ~1x1017 cm-3 which corresponds to ~25 meV in the Fermi energy is obtained in both n- and p-type materials. Electrical transport properties show that the insulating behavior is achieved in low carrier density crystals. In addition, both the band gap and reduced effective mass of carriers are determined.
arXiv comment11 pages
References in corpus (4)
- First observation of Spin-Momentum Helical Locking in Bi2Se3 and Bi2Te3, demonstration of Topological-Order at 300K and a realization of topological-transport-regime
- p-type Bi2Se3 for topological insulator and low temperature thermoelectric applications
- Quantum interference in macroscopic crystals of non-metallic BiSe
- Optical characterization of BiSe in a magnetic field: infrared evidence for magnetoelectric coupling in a topological insulator material
Cited by in corpus (20)
- Topological insulators and superconductors
- Stability, Electronic and Magnetic properties of magnetically doped topological insulators Bi2Se3, Bi2Te3 and Sb2Te3
- Growth of High-Mobility Bi2Te2Se Nanoplatelets on hBN Sheets by van der Waals Epitaxy
- Semiconductor materials stacks for quantum dot spin qubits
- Solution to the hole-doping problem and tunable quantum Hall effect in BiSe thin films
- Carrier density dependence of the magnetic properties in iron-doped Bi2Se3 topological insulator
- Field-effect mobility enhanced by tuning the Fermi level into the band gap of Bi2Se3
- Dirac states with knobs on: interplay of external parameters and the surface electronic properties of 3D topological insulators
- Interlayer Ferromagnetism and High-Temperature Quantum Anomalous Hall Effect in \textit{p}-Doped MnBiTe Multilayers
- Two-dimensional magnetotransport in Bi2Te2Se nanoplatelets
- Termination of Single Crystal Bi2Se3 Surfaces Prepared by Various Methods
- Se nuclear magnetic resonance of topological insulator BiSe
- Quantum electrical transport properties of topological insulator Bi2Te3 nanowires
- Topological Properties of SnSe/EuS and SnTe/CaTe Interfaces
- Spin transfer torques due to the bulk states of topological insulators
- Preparation of clean surfaces and Se vacancy formation in BiSe by ion bombardment and annealing
- Magneto-transport and Berry phase in magnetically doped BiSb single crystals
- The hole Fermi surface in BiSe probed by quantum oscillations
- Suspension and Measurement of Graphene and Bi2Se3 Atomic Membranes
- From classical to quantum regime of topological surface states via defect engineering