Neutron irradiation test of depleted CMOS pixel detector prototypes
arXiv:1701.05033 · doi:10.1088/1748-0221/12/02/P02021
Abstract
Charge collection properties of depleted CMOS pixel detector prototypes produced on p-type substrate of 2 kcm initial resistivity (by LFoundry 150 nm process) were studied using Edge-TCT method before and after neutron irradiation. The test structures were produced for investigation of CMOS technology in tracking detectors for experiments at HL-LHC upgrade. Measurements were made with passive detector structures in which current pulses induced on charge collecting electrodes could be directly observed. Thickness of depleted layer was estimated and studied as function of neutron irradiation fluence. An increase of depletion thickness was observed after first two irradiation steps to 110 n/cm and 510 n/cm and attributed to initial acceptor removal. At higher fluences the depletion thickness at given voltage decreases with increasing fluence because of radiation induced defects contributing to the effective space charge concentration. The behaviour is consistent with that of high resistivity silicon used for standard particle detectors. The measured thickness of the depleted layer after irradiation with 110 n/cm is more than 50 m at 100 V bias. This is sufficient to guarantee satisfactory signal/noise performance on outer layers of pixel trackers in HL-LHC experiments.
References in corpus (5)
- CMS Barrel Pixel Detector Overview
- A Monolithic active pixel sensor for ionizing radiation using a 180nm HV-SOI process
- DMAPS: a fully depleted monolithic active pixel sensor - analog performance characterization
- Prototype Active Silicon Sensor in 150 nm HR-CMOS Technology for ATLAS Inner Detector Upgrade
- From Hybrid to CMOS Pixels ... a possibility for LHC's pixel future?
Cited by in corpus (9)
- A review of advances in pixel detectors for experiments with high rate and radiation
- Radiation Hardness of Thin Low Gain Avalanche Detectors
- Charge collection properties of irradiated depleted CMOS pixel test structures
- MALTA-Cz: A radiation hard full-size monolithic CMOS sensor with small electrodes on high-resistivity Czochralski substrate
- Charge collection properties in an irradiated pixel sensor built in a thick-film HV-SOI process
- CACTUS: A depleted monolithic active timing sensor using a CMOS radiation hard technology
- Investigation of the Boron removal effect induced by 5.5 MeV electrons on highly doped EPI- and Cz-silicon
- Study of neutron irradiation effects in Depleted CMOS detector structures
- Overview of CMOS sensors for future tracking detectors