Weak-value amplification as an optimal metrological protocol

Abstract

The implementation of weak-value amplification requires the pre- and post-selection of states of a quantum system, followed by the observation of the response of the meter, which interacts weakly with the system. Data acquisition from the meter is conditioned to successful post-selection events. Here we derive an optimal post-selection procedure for estimating the coupling constant between system and meter, and show that it leads both to weak-value amplification and to the saturation of the quantum Fisher information, under conditions fulfilled by all previously reported experiments on the amplification of weak signals. For most of the pre-selected states, full information on the coupling constant can be extracted from the meter data set alone, while for a small fraction of the space of pre-selected states, it must be obtained from the post-selection statistics.

References in corpus (6)

• Ultrasensitive Beam Deflection Measurement via Interferometric Weak Value Amplification
• Complex weak values in quantum measurement
• Optimizing the Signal to Noise Ratio of a Beam Deflection Measurement with Interferometric Weak Values
• Precision frequency measurements with interferometric weak values
• Measuring ultrasmall time delays of light by joint weak measurements
• Picoradian deflection measurement with an interferometric quasi-autocollimator using weak value amplification