Effect of Etching Methods on Dielectric Losses in Transmons

Abstract

Superconducting qubits are considered as a promising platform for implementing a fault tolerant quantum computing. However, surface defects of superconductors and the substrate leading to qubit state decoherence and fluctuations in qubit parameters constitute a significant problem. The amount and type of defects depend both on the chip materials and fabrication procedure. In this work, transmons produced by two different methods of aluminum etching: wet etching in a solution of weak acids and dry etching using a chlorine-based plasma are experimentally studied. The relaxation and coherence times for dry-etched qubits are more than twice as long as those for wet-etched ones. Additionally, the analysis of time fluctuations of qubit frequencies and relaxation times, which is an effective method to identify the dominant dielectric loss mechanisms, indicates a significantly lower impact of two-level systems in the dry-etched qubits compared to the wet-etched ones.

7 pages, 6 figures

References in corpus (34)

• Supplementary information for "Quantum supremacy using a programmable superconducting processor"
• A Quantum Engineer's Guide to Superconducting Qubits
• Suppressing quantum errors by scaling a surface code logical qubit
• Dynamical decoupling and noise spectroscopy with a superconducting flux qubit
• Decoherence in Josephson Qubits from Dielectric Loss
• 1/f noise: implications for solid-state quantum information
• Towards understanding two-level-systems in amorphous solids -- Insights from quantum circuits
• Decoherence benchmarking of superconducting qubits
• Efficient and robust analysis of complex scattering data under noise in microwave resonators
• Millisecond charge-parity fluctuations and induced decoherence in a superconducting qubit
• Correlating decoherence in transmon qubits: Low frequency noise by single fluctuators
• Surface loss simulations of superconducting coplanar waveguide resonators
• Number fluctuations of sparse quasiparticles in a superconductor
• Low- and high-frequency noise from coherent two-level systems
• Observation of directly interacting coherent two-level systems in a solid
• Evidence for interacting two-level systems from the 1/f noise of a superconducting resonator
• Rotating-frame relaxation as a noise spectrum analyzer of a superconducting qubit undergoing driven evolution
• Interacting two-level defects as sources of fluctuating high-frequency noise in superconducting circuits
• High-Fidelity, Frequency-Flexible Two-Qubit Fluxonium Gates with a Transmon Coupler
• High-fidelity quantum logic operations using linear optical elements
• High fidelity two-qubit gates on fluxoniums using a tunable coupler
• Novel E-beam lithography technique for in-situ junction fabrication: the controlled undercut
• Measuring the temperature dependence of individual two-level systems by direct coherent control
• Substrate surface engineering for high-quality silicon/aluminum superconducting resonators
• Analysis of high quality superconducting resonators: consequences for TLS properties in amorphous oxides
• Error per single-qubit gate below $10^{-4}$ in a superconducting qubit
• Single photon events from neutral current interactions at MiniBooNE
• Geometric Scaling of Two-Level-System Loss in Superconducting Resonators
• Multi-level Quantum Noise Spectroscopy
• Relaxation of Josephson qubits due to strong coupling to two-level systems
• Coupler microwave-activated controlled phase gate on fluxonium qubits
• Driven-state relaxation of a coupled qubit-defect system in spin-locking measurements
• Shape optimization of superconducting transmon qubit for low surface dielectric loss
• Rabi noise spectroscopy of individual two-level tunneling defects