Performance of the EUDET-type beam telescopes
arXiv:1603.09669 · doi:10.1140/epjti/s40485-016-0033-2
Abstract
Test beam measurements at the test beam facilities of DESY have been conducted to characterise the performance of the EUDET-type beam telescopes originally developed within the EUDET project. The beam telescopes are equipped with six sensor planes using MIMOSA26 monolithic active pixel devices. A programmable Trigger Logic Unit provides trigger logic and time stamp information on particle passage. Both data acquisition framework and offline reconstruction software packages are available. User devices are easily integrable into the data acquisition framework via predefined interfaces. The biased residual distribution is studied as a function of the beam energy, plane spacing and sensor threshold. Its standard deviation at the two centre pixel planes using all six planes for tracking in a 6\,GeV electron/positron-beam is measured to be $(2.88\,\pm\,0.08)\,\upmu\meter$.Iterative track fits using the formalism of General Broken Lines are performed to estimate the intrinsic resolution of the individual pixel planes. The mean intrinsic resolution over the six sensors used is found to be $(3.24\,\pm\,0.09)\,\upmu\meter$.With a 5\,GeV electron/positron beam, the track resolution halfway between the two inner pixel planes using an equidistant plane spacing of 20\,mm is estimated to $(1.83\,\pm\,0.03)\,\upmu\meter$ assuming the measured intrinsic resolution. Towards lower beam energies the track resolution deteriorates due to increasing multiple scattering. Threshold studies show an optimal working point of the MIMOSA26 sensors at a sensor threshold of between five and six times their RMS noise. Measurements at different plane spacings are used to calibrate the amount of multiple scattering in the material traversed and allow for corrections to the predicted angular scattering for electron beams.
References in corpus (4)
Cited by in corpus (70)
- The DESY II Test Beam Facility
- Corryvreckan: A Modular 4D Track Reconstruction and Analysis Software for Test Beam Data
- EUDAQ2 -- A Flexible Data Acquisition Software Framework for Common Test Beams
- The AIDA-2020 TLU: a Flexible Trigger Logic Unit for Test Beam Facilities
- Depleted Fully Monolithic Active CMOS Pixel Sensors (DMAPS) in High Resistivity 150~nm Technology for LHC
- Beam test measurements of Low Gain Avalanche Detector single pads and arrays for the ATLAS High Granularity Timing Detector
- EUDAQ A Data Acquisition Software Framework for Common Beam Telescopes
- ADENIUM -- A demonstrator for a next-generation beam telescope at DESY
- Radiation hardness of small-pitch 3D pixel sensors up to a fluence of n/cm
- Performance of a Front End prototype ASIC for picosecond precision time measurements with LGAD sensors
- Radiation hard DMAPS pixel sensors in 150nm CMOS technology for operation at LHC
- The Monopix chips: Depleted monolithic active pixel sensors with a column-drain read-out architecture for the ATLAS Inner Tracker upgrade
- 3D silicon pixel detectors for the High-Luminosity LHC
- BDAQ53, a versatile pixel detector readout and test system for the ATLAS and CMS HL-LHC upgrades
- Radiation hard pixel sensors using high-resistive wafers in a 150 nm CMOS processing line
- MuPix7 - A fast monolithic HV-CMOS pixel chip for Mu3e
- Performance in beam tests of Carbon-enriched irradiated Low Gain Avalanche Detectors for the ATLAS High Granularity Timing Detector
- Performance of the GridPix detector quad
- Feasibility of track-based multiple scattering tomography
- Transient Monte Carlo Simulations for the Optimisation and Characterisation of Monolithic Silicon Sensors
- Effects of gamma irradiation on DEPFET pixel sensors for the Belle II experiment
- Results on Proton-Irradiated 3D Pixel Sensors Interconnected to RD53A Readout ASIC
- EUTelescope: A modular reconstruction framework for beam telescope data
- Investigation of thin n-in-p planar pixel modules for the ATLAS upgrade
- Efficiency and timing performance of the MuPix7 high-voltage monolithic active pixel sensor
- Beam test results of IHEP-NDL Low Gain Avalanche Detectors(LGAD)
- Test Beam Performance Measurements for the Phase I Upgrade of the CMS Pixel Detector
- Simulating Monolithic Active Pixel Sensors: A Technology-Independent Approach Using Generic Doping Profiles
- The DESY Digital Silicon Photomultiplier: Device Characteristics and First Test-Beam Results
- Characterization of the first prototype CMOS pixel sensor developed for the CEPC vertex detector
- Upgrading the Beam Telescopes at the DESY II Test Beam Facility
- Lycoris -- a large-area, high resolution beam telescope
- Silicon Pixel R&D for the CLIC Tracking Detector
- Towards a New Generation of Monolithic Active Pixel Sensors
- Investigations into the impact of locally modified sensor architectures on the detection efficiency of silicon micro-strip sensors
- TelePix -- A fast region of interest trigger and timing layer for the EUDET Telescopes
- Radiation tolerant, thin, passive CMOS sensors read out with the RD53A chip
- Performance of active edge pixel sensors
- Scattering studies with the DATURA beam telescope
- Test-beam characterisation of the CLICTD technology demonstrator - a small collection electrode High-Resistivity CMOS pixel sensor with simultaneous time and energy measurement
- Tracking performance and simulation of capacitively coupled pixel detectors for the CLIC vertex detector
- Performance of Thin Planar \textit{n-on-p} silicon pixels after HL-LHC radiation fluences
- Silicon Vertex & Tracking Detectors for the Compact Linear Collider
- R&D for the CLIC Vertex and Tracking detectors
- Characterization of irradiated RD53A pixel modules with passive CMOS sensors
- Thin and edgeless sensors for ATLAS pixel detector upgrade
- Radiation hardness of small-pitch 3D pixel sensors up to HL-LHC fluences
- Developing a Monolithic Silicon Sensor in a 65 nm CMOS Imaging Technology for Future Lepton Collider Vertex Detectors
- Optimization of thin n-in-p planar pixel modules for the ATLAS upgrade at HL-LHC
- Performance of production modules of the Belle II pixel detector in a high-energy particle beam
- The Measurement of Position Resolution of RD53A Pixel Modules
- Operation of a double-sided CMOS pixelated detector at a high intensity particle collider
- Mapping the material distribution of a complex structure in an electron beam
- Depth-dependent charge collection profile of pad diodes
- Test-beam and simulation studies for the CLICTD technology demonstrator -- a monolithic CMOS pixel sensor with a small collection diode
- Test beam measurements and computer simulations of the ATLAS ITk R2 silicon strip detector
- Investigation of modified ATLAS pixel implantations after irradiation with neutrons
- Planar n-in-n quad module prototypes for the ATLAS ITk upgrade at HL-LHC
- LYCORIS - A Large Area Strip Telescope
- Subpixel Mapping and Test Beam Studies with a HV2FEI4v2 CMOS-Sensor-Hybrid Module for the ATLAS Inner Detector Upgrade
- Precision determination of the track-position resolution of beam telescopes
- Performance Studies of the ATLASpix HV-MAPS Prototype for Different Substrate Resistivities
- Position resolution with 25 um pitch pixel sensors before and after irradiation
- Cherenkov Diffraction Radiation Emissions from Single Electrons and Positrons on a Fused Silica Radiator
- Comparison of different sensor thicknesses and substrate materials for the monolithic small collection-electrode technology demonstrator CLICTD
- The EXTRA-BL4S experiment for the measurement of the energy and angular distributions of transition radiation X-rays
- First Annealing Studies of Irradiated Silicon Sensors with Modified ATLAS Pixel Implantations
- Towards High-Efficiency Particle Detection Using Superconducting Microwire Arrays
- Test Beam Characterization of a Digital Silicon Photomultiplier
- Construction of the new silicon microstrips tracker for the Phase-II ATLAS detector