Low-Frequency 1/f Noise in MoS2 Thin-Film Transistors: Comparison of Single and Multilayer Structures
arXiv:1503.01823 · doi:10.1109/LED.2015.2412536
Abstract
We report on the transport and low-frequency noise measurements of MoS2 thin-film transistors with "thin" (2-3 atomic layers) and "thick" (15-18 atomic layers) channels. The back-gated transistors made with the relatively thick MoS2 channels have advantages of the higher electron mobility and lower noise level. The normalized noise spectral density of the low-frequency 1/f noise in "thick" MoS2 transistors is of the same level as that in graphene. The MoS2 transistors with the atomically thin channels have substantially higher noise levels. It was established that, unlike in graphene devices, the noise characteristics of MoS2 transistors with "thick" channels (15-18 atomic planes) could be described by the McWhorter model. Our results indicate that the channel thickness optimization is crucial for practical applications of MoS2 thin-film transistors.
12 pages, 3 figures
References in corpus (3)
Cited by in corpus (9)
- Low-Frequency Electronic Noise in Exfoliated Quasi-1D TaSe3 van Der Waals Nanowires
- Gas Sensing with h-BN Capped MoS2 Heterostructure Thin Film Transistors
- Effect of High-k Dielectric Layer on 1/f Noise Behavior in Graphene Field-Effect Transistors
- Velocity Saturation effect on Low Frequency Noise in short channel Single Layer Graphene FETs
- Experimental detection of active defects in few layers MoS2 through random telegraphic signals analysis observed in its FET characteristics
- Lateral plasmonic crystals: Tunability, dark modes, and weak-to-strong coupling transition
- Photodoping-driven crossover in low-frequency noise in MoS2 transistors
- Physics-based bias-dependent compact modeling of 1/f noise in single- to few- layer 2D-FETs
- Amplitude and Phase Noise of Magnons