Measurements of mechanical thermal noise and energy dissipation in optical dielectric coatings

Abstract

In recent years an increasing number of devices and experiments are shown to be limited by mechanical thermal noise. In particular sub-Hertz laser frequency stabilization and gravitational wave detectors, that are able to measure fluctuations of 1E-18 m/rtHz or less, are being limited by thermal noise in the dielectric coatings deposited on mirrors. In this paper we present a new measurement of thermal noise in low absorption dielectric coatings deposited on micro-cantilevers and we compare it with the results obtained from the mechanical loss measurements. The coating thermal noise is measured on the widest range of frequencies with the highest signal to noise ratio ever achieved. In addition we present a novel technique to deduce the coating mechanical losses from the measurement of the mechanical quality factor which does not rely on the knowledge of the coating and substrate Young moduli. The dielectric coatings are deposited by ion beam sputtering. The results presented here give a frequency independent loss angle of (4.70 $\pm$ 0.2)x1E-4 with a Young's modulus of 118 GPa for annealed tantala from 10 Hz to 20 kHz. For as-deposited silica, a weak frequency dependence (~ f^{-0.025}) is observed in this frequency range, with a Young's modulus of 70 GPa and an internal damping of (6.0 $\pm$ 0.3)x1E-4 at 16 kHz, but this value decreases by one order of magnitude after annealing and the frequency dependence disappears.

Accepted for publication in Phys. Rev. D

References in corpus (2)

• Titania-doped tantala/silica coatings for gravitational-wave detection
• Frequency dependence of viscous and viscoelastic dissipation in coated micro-cantilevers from noise measurement

Cited by in corpus (17)

• Amorphous optical coatings of present gravitational-wave interferometers
• Mechanical loss in state-of-the-art amorphous optical coatings
• Low mechanical loss TiO${}_2$:GeO${}_2$ coatings for reduced thermal noise in Gravitational Wave Interferometers
• Progress in the measurement and reduction of thermal noise in optical coatings for gravitational-wave detectors
• High-Reflection Coatings for Gravitational-Wave Detectors: State of The Art and Future Developments
• Optical and mechanical properties of ion-beam-sputtered Nb${}_2$O${}_5$ and TiO${}_2$-Nb${}_2$O${}_5$ thin films for gravitational-wave interferometers
• Material loss angles from direct measurements of broadband thermal noise
• Resonance frequency shift of strongly heated micro-cantilevers
• Exploration of co-sputtered Ta${}_2$O${}_5$-ZrO${}_2$ thin films for gravitational-wave detectors
• Low thermal fluctuations in a system heated out of equilibrium
• Broadband Measurement of Coating Thermal Noise in Rigid Fabry-Perot Cavities
• Silicon cantilevers locally heated from 300K up to the melting point: temperature profile measurement from their resonances frequency shift
• Optical and mechanical properties of ion-beam-sputtered MgF${}_2$ thin films for gravitational-wave interferometers
• A method for the experimental measurement of bulk and shear loss angles in amorphous thin films
• Strategies to reduce the thermoelastic loss of multimaterial coated finite substrates
• Linking fluctuation and dissipation in spatially extended out-of-equilibrium systems
• Characterization of ion-beam-sputtered AlF${}_3$ thin films for gravitational-wave interferometers