A comparsion of force sensors for atomic force microscopy based on quartz tuning forks and length extensional resonators
arXiv:1104.2987 · doi:10.1103/PhysRevB.84.125409
Abstract
The force sensor is key to the performance of atomic force microscopy (AFM). Nowadays, most AFMs use micro-machined force sensors made from silicon, but piezoelectric quartz sensors are applied at an increasing rate, mainly in vacuum. These self sensing force sensors allow a relatively easy upgrade of a scanning tunneling microscope to a combined scanning tunneling/atomic force microscope. Two fundamentally different types of quartz sensors have achieved atomic resolution: the 'needle sensor' that is based on a length extensional resonator and the 'qPlus sensor' that is based on a tuning fork. Here, we calculate and measure the noise characteristics of these sensors. We find four noise sources: deflection detector noise, thermal noise, oscillator noise and thermal drift noise. We calculate the effect of these noise sources as a factor of sensor stiffness, bandwidth and oscillation amplitude. We find that for self sensing quartz sensors, the deflection detector noise is independent of sensor stiffness, while the remaining three noise sources increase strongly with sensor stiffness. Deflection detector noise increases with bandwidth to the power of 1.5, while thermal noise and oscillator noise are proportional to the square root of the bandwidth. Thermal drift noise, however, is inversely proportional to bandwidth. The first three noise sources are inversely proportional to amplitude while thermal drift noise is independent of the amplitude. Thus, we show that the earlier finding that quoted optimal signal-to-noise ratio for oscillation amplitudes similar to the range of the forces is still correct when considering all four frequency noise contributions. Finally, we suggest how the signal-to-noise ratio of the sensors can be further improved and briefly discuss the challenges of mounting tips.
40 pages, 14 figures
References in corpus (4)
- Local spectroscopy and atomic imaging of tunneling current, forces and dissipation on graphite
- A phantom force induced by the tunneling current, characterized on Si(111)
- Application of the equipartition theorem to the thermal excitation of quartz tuning forks
- Searching atomic spin contrast on nickel oxide (001) by force microscopy
Cited by in corpus (10)
- Optimizing atomic resolution of force microscopy in ambient conditions
- A self-calibrating optomechanical force sensor with femtonewton resolution
- Scanning probe microscopy and spectroscopy of graphene on metals
- Facet Dependent Topological Phase Transition in Bi4Br4
- MicroMegascope
- A Transimpedance Amplifier for Remotely Located Quartz Tuning Forks
- An ultra-compact low temperature scanning probe microscope for magnetic fields above 30 T
- Versatile Variable Temperature and Magnetic Field Scanning Probe Microscope for Advanced Material Research
- Nanoscale Non-Destructive Ferroelectric Characterization with Non-Contact Heterodyne Electrostrain Force Microscopy
- Force-noise spectroscopy by tunnelling current deflection sensing