Time resolution of time-of-flight detector based on multiple scintillation counters readout by SiPMs
arXiv:1511.03891 · doi:10.1016/j.nima.2016.05.038
Abstract
A new timing detector measuring ~50 MeV/c positrons is under development for the MEG II experiment, aiming at a time resolution . The resolution is expected to be achieved by measuring each positron time with multiple counters made of plastic scintillator readout by silicon photomultipliers (SiPMs). The purpose of this work is to demonstrate the time resolution for ~50 MeV/c positrons using prototype counters. Counters with dimensions of readout by six SiPMs (three on each plane) were built with SiPMs from Hamamatsu Photonics and AdvanSiD and tested in a positron beam at the DANE Beam Test Facility. The time resolution was found to improve nearly as the square root of the number of counter hits. A time resolution was obtained with eight counters with Hamamatsu SiPMs. These results suggest that the design resolution is achievable in the MEG II experiment.
12 pages, 18 figures. Published in NIM A
References in corpus (12)
- Design and Construction of the BESIII Detector
- MEG Upgrade Proposal
- The MEG detector for decay search
- Search for physics beyond the standard model in events with tau leptons, jets, and large transverse momentum imbalance in pp collisions at sqrt(s) = 7 TeV
- Development of High Precision Timing Counter Based on Plastic Scintillator with SiPM Readout
- The design and commissioning of the MICE upstream time-of-flight system
- Novel Calibration Method for Switched Capacitor Arrays Enables Time Measurements with Sub-Picosecond Resolution
- A time-resolution study with a plastic scintillator read out by a Geiger-mode Avalanche Photodiode
- Large-Area Scintillator Hodoscope with 50 ps Timing Resolution Onboard BESS
- Development and commissioning of the Timing Counter for the MEG Experiment
- Design and test of an extremely high resolution Timing Counter for the MEG II experiment: preliminary results
- Characterization of a tagged -ray beam line at the DANE Beam Test Facility