Dynamics of quartz tuning fork force sensors used in scanning probe microscopy

Abstract

We have performed an experimental characterization of the dynamics of oscillating quartz tuning forks which are being increasingly used in scanning probe microscopy as force sensors. We show that tuning forks can be described as a system of coupled oscillators. Nevertheless, this description requires the knowledge of the elastic coupling constant between the prongs of the tuning fork, which has not yet been measured. Therefore tuning forks have been usually described within the single oscillator or the weakly coupled oscillators approximation that neglects the coupling between the prongs. We propose three different procedures to measure the elastic coupling constant: an opto-mechanical method, a variation of the Cleveland method and a thermal noise based method. We find that the coupling between the quartz tuning fork prongs has a strong influence on the dynamics and the measured motion is in remarkable agreement with a simple model of coupled harmonic oscillators. The precise determination of the elastic coupling between the prongs of a tuning fork allows to obtain a quantitative relation between the resonance frequency shift and the force gradient acting at the free end of a tuning fork prong.

16 pages, 6 figures, 2 Tables

References in corpus (4)

• Phase controlled superconducting proximity effect probed by tunneling spectroscopy
• Low-temperature, high-resolution magnetic force microscopy using a quartz tuning fork
• Force-distance studies with piezoelectric tuning forks below 4.2 K
• Combined scanning force microscopy and scanning tunneling spectroscopy of an electronic nano-circuit at very low temperature

Cited by in corpus (13)

• A self-calibrating optomechanical force sensor with femtonewton resolution
• Force-gradient-induced mechanical dissipation of quartz tuning fork force sensors used in atomic force microscopy
• Spatially resolved electronic inhomogeneities of graphene due to subsurface charges
• Cooling a harmonic oscillator by optomechanical modification of its bath
• Carbon fibre tips for scanning probe microscopy based on quartz tuning fork force sensors
• Controlling the quality factor of a tuning-fork resonance between 9 K and 300 K for scanning-probe microscopy
• Calibration of piezoelectric positioning actuators using a reference voltage-to-displacement transducer based on quartz tuning forks
• Carbon-fiber tips for scanning probe microscopes and molecular electronics experiments
• A simple method to characterize the electrical and mechanical properties of micro-fibers
• FM-AFM with hanging fiber probe for the study of liquid / liquid interfaces
• A simple strobe to study high-order harmonics and multifrequency oscillations in mechanical resonators
• Calibrating conservative and dissipative response of electrically-driven quartz tuning forks
• Enhancing sensitivity in atomic force microscopy for planar tip-on-chip probes