Flicker noise in high-speed p-i-n photodiodes
arXiv:physics/0503022 · doi:10.1109/TMTT.2005.863062
Abstract
The microwave signal at the output of a photodiode that detects a modulated optical beam contains the phase noise phi(t) and the amplitude noise alpha(t) of the detector. Beside the white noise, which is well understood, the spectral densities S_phi(f) and S_alpha(f) show flicker noise, proportional to 1/f. We report on the measurement of the phase and amplitude noise of high-speed p-i-n photodiodes. The main result is that the flicker coefficient of the samples is approximately 1E-12 rad^2/Hz (-120dB) for phase noise, and approximately 1E-12 Hz^-1 (-120dB) for amplitude noise. These values could be observed only after solving a number of experimental problems and in a protected environment. By contrast, in ordinary conditions insufficient EMI isolation, and also insufficient mechanical isolation, are responsible for additional noise to be taken in. This suggests that if package and EMC are revisited, applications can take the full benefit from the surprisingly low noise of the p-i-n photodiodes.
arXiv comment11 pages, 3 figures, 24 references
References in corpus (1)
Cited by in corpus (6)
- Characterization of Power-to-Phase Conversion in High-Speed P-I-N Photodiodes
- Ultralow phase noise microwave generation with an Er:fiber-based optical frequency divider
- Applications of the optical fiber to the generation and to the measurement of low-phase-noise microwave signals
- Suppression of amplitude-to-phase noise conversion in balanced optical-microwave phase detectors
- Advanced noise reduction techniques for ultra-low phase noise optical-to-microwave division with femtosecond fiber combs
- Hänsch-Couillaud locking of a large Sagnac interferometer: advancing below the flicker floor