Suppression of amplitude-to-phase noise conversion in balanced optical-microwave phase detectors
arXiv:1309.1116 · doi:10.1364/OE.21.027057
Abstract
We demonstrate an amplitude-to-phase (AM-PM) conversion coefficient for a balanced optical-microwave phase detector (BOM-PD) of 0.001 rad, corresponding to AM-PM induced phase noise 60 dB below the single-sideband relative intensity noise of the laser. This enables us to generate 8 GHz microwave signals from a commercial Er-fibre comb with a single-sideband residual phase noise of -131 dBc/Hz at 1 Hz offset frequency and -148 dBc/Hz at 1 kHz offset frequency.
References in corpus (11)
- Generation of Ultrastable Microwaves via Optical Frequency Division
- Sub-femtosecond synchronization of microwave oscillators with mode-locked Er-fiber lasers
- An Optical Fibre Pulse Rate Multiplier for Ultra-low Phase-noise Signal Generation
- Characterization of Power-to-Phase Conversion in High-Speed P-I-N Photodiodes
- Sub-100-as timing jitter optical pulse trains from mode-locked Er-fiber lasers
- Photonic microwave generation with high-power photodiodes
- Amplitude to phase conversion of InGaAs pin photo-diodes for femtosecond lasers microwave signal generation
- Ultralow phase noise microwave generation with an Er:fiber-based optical frequency divider
- Sub-100 attoseconds optics-to-microwave synchronization
- Flicker noise in high-speed p-i-n photodiodes
- Advanced noise reduction techniques for ultra-low phase noise optical-to-microwave division with femtosecond fiber combs