Qubit measurements with a double-dot detector
arXiv:cond-mat/0606376 · doi:10.1103/PhysRevLett.97.116806
Abstract
We propose to monitor a qubit with a double-dot (DD) resonant-tunneling detector, which can operate at higher temperatures than a single-dot detector. In order to assess the effectiveness of this device, we derive rate equations for the density matrix of the entire system. We show that the signal-to-noise ratio can be greatly improved by a proper choice of the parameters and location of the detector. We demonstrate that quantum interference effects within the DD detector play an important role in the measurement. Surprisingly, these effects produce a systematic measurement error, even when the entire system is in a stationary state.
4 pages, some explanations added, Phys. Rev. Lett., in press
References in corpus (13)
- An Electronic Mach-Zehnder Interferometer
- Microscopic derivation of rate equations for quantum transport
- Measurements with a noninvasive detector and dephasing mechanism
- Rate equations for quantum transport in multi-dot systems
- Output spectrum of a detector measuring quantum oscillations
- Quantum limited sensitivity of SET-based displacement detectors
- Interference effects in resonant magneto-transport
- Single qubit measurements with an asymmetric single-electron transistor
- Quantum interference in resonant tunneling and single spin measurements
- Measurement of Two-Qubit States by a Two-Island Single Electron Transistor
- Theory of a double-dot charge detector
- Radio-frequency operation of a double-island single-electron transistor
- Negative result measurements in mesoscopic systems
Cited by in corpus (24)
- Calculation of the current noise spectrum in mesoscopic transport: an efficient quantum master equation approach
- Quantum mechanical approach to decoherence and relaxation generated by fluctuating environment
- The information about the state of a qubit gained by a weakly coupled detector
- Weak and strong measurement of a qubit using a switching-based detector
- Optimal post-processing for a generic single-shot qubit readout
- Geometric phase of a quantum dot system in nonunitary evolution
- Fano-Kondo effect through two-level system based on quantum dots
- Optimal Control of Quantum Measurement
- Quantum measurement characteristics of double-dot single electron transistor
- Full Counting statistics of level renormalization in electron transport through double quantum dots
- Coherent quantum ratchets driven by tunnel oscillations: Fluctuations and correlations
- Spin detection at elevated temperatures using a driven double quantum dot
- Phase readout of a charge qubit capacitively coupled to an open double quantum dot
- Monitoring quantum transport: Backaction and measurement correlations
- Reduced dynamics with renormalization in solid-state charge qubit measurement
- Non-Markovian dynamics and noise characteristics in continuous measurement of a solid-state charge qubit
- Fano-Kondo effect in a two-level system with triple quantum dots: shot noise characteristics
- Renormalized dynamics in charge qubit measurements by a single electron transistor
- Simple theory of the measured current through quantum dots
- Robustness of Charge-Qubit Cluster States to Double Quantum Point Contact Measurement
- Edge-state Fabry-Perot interferometer as a high sensitivity charge detector
- Cross correlations in mesoscopic charge detection
- Perturbative approach to the capacitive interaction between a sensor quantum dot and a charge qubit
- Double detected spin-dependent quantum dot