Output spectrum of a measuring device at arbitrary voltage and temperature
arXiv:cond-mat/0311325 · doi:10.1209/epl/i2003-10309-6
Abstract
We calculate the noise spectrum of the electrical current in a quantum point contact which is used for continuous measurements of a two-level system (qubit). We generalize the previous results obtained for the regime of high transport voltages (when is much larger than the qubit's energy level splitting (we put )) to the case of arbitrary voltages and temperatures. When the background output spectrum is essentially asymmetric in frequency, i.e., it is no longer classical. Yet, the spectrum of the amplified signal, i.e., the two coherent peaks at is still symmetric. In the emission (negative frequency) part of the spectrum the coherent peak can be 8 times higher than the background pedestal. Alternatively, this ratio can be seen in the directly measureable {\it excess} noise. For and T=0 the coherent peaks do not appear at all. We relate these results to the properties of linear amplifiers.
arXiv comment7 pages, 5 figures, the results generalized for arbitrary angle between the magnetic field and the observed component of the spin, minor corrections and typos
References in corpus (16)
- Manipulating the Quantum State of an Electrical Circuit
- Coherent Quantum Dynamics of a Superconducting Flux Qubit
- Measurements with a noninvasive detector and dephasing mechanism
- Double Quantum Dots as Detectors of High-Frequency Quantum Noise in Mesoscopic Conductors
- Continuous quantum measurement of a double dot
- Continuous weak measurement of quantum coherent oscillations
- Quantum Measurements Performed with a Single-Electron Transistor
- Quantum-Limited Measurement and Information in Mesoscopic Detectors
- Efficiency of Mesoscopic Detectors
- Dynamics of a mesoscopic qubit under continuous quantum measurement
- Output spectrum of a detector measuring quantum oscillations
- Charge Distribution in a Kondo Correlated Quantum Dot
- Spin-spin correlators in Majorana representation
- Spin dynamics from Majorana fermions
- Spectrum of qubit oscillations from Bloch equations
- Tunneling measurement of quantum spin oscillations
Cited by in corpus (18)
- Experimental violation of a Bell's inequality in time with weak measurement
- Low- and high-frequency noise from coherent two-level systems
- Signatures of quantum behavior in single-qubit weak measurements
- Qubit feedback and control with kicked quantum nondemolition measurements: A quantum Bayesian analysis
- Frequency-Dependent Current Noise through Quantum-Dot Spin Valves
- Continuous quantum measurement with independent detector cross-correlations
- Tunneling Spectroscopy of Two-level Systems Inside Josephson Junction
- Continuous quantum feedback of coherent oscillations in a solid-state qubit
- Voltage dependence of Landau-Lifshitz-Gilbert damping of a spin in a current driven tunnel junction
- Quantum Zeno stabilization in weak continuous measurement of two qubits
- Spin Lifetimes in Quantum Dots from Noise Measurements
- Comment on "Continuous quantum measurement: inelastic tunneling and lack of current oscillations"
- Non-Markovian dynamics and noise characteristics in continuous measurement of a solid-state charge qubit
- Reply to Comment on "Continuous quantum measurement: inelastic tunneling and lack of current oscillations"
- Persistent Rabi oscillations probed via low-frequency noise correlation
- Continuous measurements of two qubits
- Spin-Orbit Scattering and Time-Reversal Symmetry: Detection of a Spin by Tunneling
- Qubit measurement using a quantum point contact with a quantum Langevin equation approach