Circle fit optimization for resonator quality factor measurements: point redistribution for maximal accuracy

Abstract

The control of material loss mechanisms is playing an increasingly important role for improving coherence times of superconducting quantum devices. Such material losses can be characterized through the measurement of planar superconducting resonators, which reflect losses through the resonance's quality factor $Q_l$. The resonance quality factor consists of both internal (material) losses as well as coupling losses when resonance photons escape back into the measurement circuit. The combined losses are then described as $Q_l^{-1}=\mathrm{Re}\{Q_c^{-1}\}+Q_i^{-1}$, where $Q_c$ and $Q_i$ reflect the coupling and internal quality factors of the resonator, respectively. To separate the relative contributions of $Q_i$ and $Q_c$ to $Q_l$, diameter-correcting circle fits use algebraic or geometric means to fit the resonance signal on the complex plane. However, such circle fits can produce varied results, so to address this issue, we use a combination of simulation and experiment to determine the reliability of a fitting algorithm across a wide range of quality factor values from $Q_i\ll Q_c$ to $Q_c\ll Q_i$. In addition, we develop a novel measurement protocol that can not only reduce fitting errors by factors $\gtrsim 2$ but also mitigates the influence of the measurement background on the fit results. This technique can be generalized for other resonance systems beyond superconducting resonators.

13 pages, 7 figures

References in corpus (8)

• Coplanar Waveguide Resonators for Circuit Quantum Electrodynamics
• Efficient and robust analysis of complex scattering data under noise in microwave resonators
• Reducing intrinsic loss in superconducting resonators by surface treatment and deep etching of silicon substrates
• Microwave response of vortices in superconducting thin films of Re and Al
• Characterization and Reduction of Capacitive Loss Induced by Sub-Micron Josephson Junction Fabrication in Superconducting Qubits
• Contribution of dielectrics to frequency and noise of NbTiN superconducting resonators
• Fano Interference in Microwave Resonator Measurements
• Material matters in superconducting qubits

Cited by in corpus (2)

• Thin-film quartz for high-coherence piezoelectric phononic crystal resonators
• Loss tangent fluctuations due to two-level systems in superconducting microwave resonators