A full relativistic thin disc -- the physics of the plunging region and the value of the stress at the ISCO
arXiv:2104.09951 · doi:10.1093/mnras/stab636
Abstract
The widely used Novikov-Thorne relativistic thin disc equations are only valid down to the radius of the innermost stable circular orbit (ISCO). This leads to an undetermined boundary condition at the ISCO, known as the inner stress of the disc, which sets the luminosity of the disc at the ISCO and introduces considerable ambiguity in accurately determining the mass, spin and accretion rate of black holes from observed spectra. We resolve this ambiguity by self-consistently extending the relativistic disc solution through the ISCO to the black hole horizon by calculating the inspiral of an average disc particle subject to turbulent disc forces, using a new particle-in-disc technique. Traditionally it has been assumed that the stress at the ISCO is zero, with material plunging approximately radially into the black hole at close to the speed of light. We demonstrate that in fact the inspiral is less severe, with several (~4-17) orbits completed before the horizon. This leads to a small non-zero stress and luminosity at and inside the ISCO, with a local surface temperature at the ISCO between ~0.15 and 0.3 times the maximum surface temperature of the disc, in the case where no dynamically important net magnetic field is present. For a range of disc parameters we calculate the value of the inner stress/surface temperature, which is required when fitting relativistic thin disc models to observations. We resolve a problem in relativistic slim disc models in which turbulent heating becomes inaccurate and falls to zero inside the plunging region.
27 pages, 8 figures, accepted for publication in MNRAS
References in corpus (11)
- First M87 Event Horizon Telescope Results. I. The Shadow of the Supermassive Black Hole
- X-ray Properties of Black-Hole Binaries
- Modelling the behaviour of accretion flows in X-ray binaries
- Stability of Relativistic Jets from Rotating, Accreting Black Holes via Fully Three-Dimensional Magnetohydrodynamic Simulations
- The Influence of Magnetic Field Geometry on the Evolution of Black Hole Accretion Flows: Similar Disks, Drastically Different Jets
- MHD simulations of the magnetorotational instability in a shearing box with zero net flux. II. The effect of transport coefficients
- MHD simulations of the magnetorotational instability in a shearing box with zero net flux. I. The issue of convergence
- Three-Dimensional Simulations of Magnetized Thin Accretion Disks around Black Holes: Stress in the Plunging Region
- Slim disks around Kerr black holes revisited
- Where is the Radiation Edge in Magnetized Black Hole Accretion discs?
- Viscous Torque and Dissipation in the Inner Region of a Thin Accretion Disk: Implications for Measuring Black Hole Spin
Cited by in corpus (3)
- Spinning black holes magnetically connected to a Keplerian disk -- Magnetosphere, reconnection sheet, particle acceleration and coronal heating
- Accretion within the innermost stable circular orbit: analytical thermodynamic solutions in the adiabatic limit
- A rapid black hole spin or emission from the plunging region?