Nonstationary force sensing under dissipative mechanical quantum squeezing
arXiv:2007.13051 · doi:10.1103/PhysRevA.102.053515
Abstract
We study the stationary and nonstationary measurement of a classical force driving a mechanical oscillator coupled to an electromagnetic cavity under two-tone driving. For this purpose, we develop a theoretical framework based on the signal-to-noise ratio to quantify the sensitivity of linear spectral measurements. Then, we consider stationary force sensing and study the necessary conditions to minimise the added force noise. We find that imprecision noise and back-action noise can be arbitrarily suppressed by manipulating the amplitudes of the input coherent fields, however, the force noise power spectral density cannot be reduced below the level of thermal fluctuations. Therefore, we consider a nonstationary protocol that involves non-thermal dissipative state preparation followed by a finite time measurement, which allows one to perform measurements with a signal-to-noise much greater than the maximum possible in a stationary measurement scenario. We analyse two different measurement schemes in the nonstationary transient regime, a back-action evading measurement, which implies modifying the drive asymmetry configuration upon arrival of the force, and a nonstationary measurement that leaves the drive asymmetry configuration unchanged. Conditions for optimal force noise sensitivity are determined, and the corresponding force noise power spectral densities are calculated.
27 pages, 10 figures
References in corpus (13)
- Quantum Theory of Cavity-Assisted Sideband Cooling of Mechanical Motion
- Theory of ground state cooling of a mechanical oscillator using dynamical back-action
- A Spin Entanglement Witness for Quantum Gravity
- Gravitationally-induced entanglement between two massive particles is sufficient evidence of quantum effects in gravity
- Back-action evasion and squeezing of a mechanical resonator using a cavity detector
- Two-mode squeezed states in cavity optomechanics via engineering of a single reservoir
- Force-detected nuclear magnetic resonance: Recent advances and future challenges
- Quantum back-action evading measurement of collective mechanical modes
- Nanomechanical squeezing with detection via a microwave cavity
- Robust force sensing for a free particle in a dissipative optomechanical system with a parametric amplifier
- Coherent Cancellation of Backaction Noise in optomechanical Force Measurements
- Gravitational wave detection beyond the standard quantum limit using a negative-mass spin system and virtual rigidity
- Quantum-limited force measurement with an optomechanical device