paper

All-2D Material Inkjet-Printed Capacitors: Towards Fully-Printed Integrated Circuits

arXiv:1812.05712 · doi:10.1021/acsnano.8b06464

Abstract

A well-defined insulating layer is of primary importance in the fabrication of passive (e.g. capacitors) and active (e.g. transistors) components in integrated circuits. One of the most widely known 2-Dimensional (2D) dielectric materials is hexagonal boron nitride (hBN). Solution-based techniques are cost-effective and allow simple methods to be used for device fabrication. In particular, inkjet printing is a low-cost, non-contact approach, which also allows for device design flexibility, produces no material wastage and offers compatibility with almost any surface of interest, including flexible substrates. In this work we use water-based and biocompatible graphene and hBN inks to fabricate all-2D material and inkjet-printed capacitors. We demonstrate an areal capacitance of 2.0 \pm 0.3 nF cm^(-2) for a dielectric thickness of \sim 3 μm and negligible leakage currents, averaged across more than 100 devices. This gives rise to a derived dielectric constant of 6.1 \pm 1.7. The inkjet printed hBN dielectric has a breakdown field of 1.9 \pm 0.3 MV cm^(-1). Fully printed capacitors with sub-/mu m hBN layer thicknesses have also been demonstrated. The capacitors are then exploited in two fully printed demonstrators: a resistor-capacitor (RC) low-pass filter and a graphene-based field effect transistor.

This document is the unedited Author's version of a Submitted Work that was subsequently accepted for publication in ACS Nano, American Chemical Society after peer review. To access the final edited and published work see DOI: 10.1021/acsnano.8b06464

References in corpus (7)

Cited by in corpus (6)