Effect of Low Temperature Baking in Nitrogen on the Performance of a Niobium Superconducting Radio Frequency Cavity
arXiv:1711.03991 · doi:10.1103/PhysRevAccelBeams.21.032001
Abstract
We report the rf performance of a single-cell superconducting radiofrequency cavity after low temperature baking in a nitrogen environment. A significant increase in quality factor has been observed when the cavity was heat treated in the temperature range of 120-160 °C with a nitrogen partial pressure of ~25 mTorr. This increase in quality factor as well as the Q-rise phenomenon (anti-Q-slope) is similar to those previously obtained with high temperature nitrogen doping as well as titanium doping. In this study, a cavity N2-treated at 120 °C and at140 °C, showed no degradation in accelerating gradient, however the accelerating gradient was degraded by 25 with a 160 °C N2 treatment. Sample coupons treated in the same conditions as the cavity were analyzed by scanning electron microscope, x-ray photoelectron spectroscopy and secondary ion mass spectroscopy revealed a complex surface composition of Nb_2O5, NbO and NbN(1-x)Ox within the rf penetration depth. Furthermore, magnetization measurements showed no significant change on bulk superconducting properties.
References in corpus (9)
- Nitrogen and argon doping of niobium for superconducting radio frequency cavities: a pathway to highly efficient accelerating structures
- Unprecedented Quality Factors at Accelerating Gradients up to 45 MV/m in Niobium Superconducting Resonators via Low Temperature Nitrogen Infusion
- Effect of high temperature heat treatments on the quality factor of a large-grain superconducting radio-frequency niobium cavity
- Surface impedance and optimum surface resistance of a superconductor with imperfect surface
- Efficient expulsion of magnetic flux in superconducting RF cavities for high applications
- Proximity breakdown of hydrides in superconducting niobium cavities
- Reduction of Dissipative Nonlinear Conductivity of Superconductors by Static and Microwave Magnetic Fields
- Reply to "Comment on the 'Decrease of the surface resistance in superconducting niobium resonator cavities by the microwave field'"
- Enhancement in Quality Factor of SRF Niobium Cavities by Material Diffusion
Cited by in corpus (15)
- Field-dependent nonlinear surface resistance and its optimization by surface nano-structuring in superconductors
- Superfluid flow in disordered superconductors with Dynes pair-breaking scattering: depairing current, kinetic inductance, and superheating field
- Superheating fields of semi-infinite superconductors and layered superconductors in the diffusive limit: structural optimization based on the microscopic theory
- Effects of nonmagnetic impurities and subgap states on the kinetic inductance, complex conductivity, quality factor and depairing current density
- On the quest of low temperature nitrogen infusion relevant for superconducting Nb based radio-frequency cavities
- Revealing the role of nitrogen on hydride nucleation and stability in pure niobium using first principles calculations
- Dissipative conductivity of a dirty superconductor with Dynes subgap states under a dc bias current up to the depairing current density
- High Frequency Nonlinear Response of Superconducting Cavity-Grade Nb surfaces
- Modelling dielectric loss in superconducting resonators: Evidence for interacting atomic two-level systems at the Nb/oxide interface
- Evidence for current suppression in superconductor-superconductor bilayers
- Tuning critical field, critical current, and diode effect of narrow thin-film superconductors through engineering inhomogeneous Pearl length
- Evaluation of predictive correlation between flux expulsion and grain growth for superconducting radio frequency cavities
- Search for inhomogeneous Meissner screening in Nb induced by low-temperature surface treatments
- Improved high-gradient performance for medium-velocity superconducting half-wave resonators: Surface preparation and trapped flux mitigation
- RF surface resistance tuning of superconducting niobium via thermal diffusion of native oxide