Etch-Tuning and Design of Silicon Nitride Photonic Crystal Reflectors
arXiv:1609.00858
Abstract
By patterning a freestanding dielectric membrane into a photonic crystal reflector (PCR), it is possible to resonantly enhance its normal-incidence reflectivity, thereby realizing a thin, single-material mirror. In many PCR applications, the operating wavelength (e.g. that of a low-noise laser or emitter) is not tunable, imposing tolerances on crystal geometry that are not reliably achieved with standard nanolithography. Here we present a gentle technique to finely tune the resonant wavelength of a SiN PCR using iterative hydrofluoric acid etches. With little optimization, we achieve a 57-nm-thin photonic crystal having an operating wavelength within 0.15 nm (0.04 resonance linewidths) of our target (1550 nm). Our thin structure exhibits a broader and less pronounced transmission dip than is predicted by plane wave simulations, and we identify two effects leading to these discrepancies, both related to the divergence angle of a collimated laser beam. To overcome this limitation in future devices, we distill a series of simulations into a set of general design considerations for realizing robust, high-reflectivity resonances.
arXiv comment6 pages, 3 figures, 1 table
References in corpus (9)
- Cavity Optomechanics
- Strong and Tunable Nonlinear Optomechanical Coupling in a Low-Loss System
- Mechanical Resonators for Quantum Optomechanics Experiments at Room Temperature
- Cavity optomechanics with stoichiometric SiN films
- Ultralow-Noise SiN Trampoline Resonators for Sensing and Optomechanics
- Integration of fiber coupled high-Q silicon nitride microdisks with atom chips
- High-reflectivity, high-Q micromechanical membranes via guided resonances for enhanced optomechanical coupling
- Laser Optomechanics
- From membrane-in-the-middle to mirror-in-the-middle with a high-reflectivity sub-wavelength grating