Electronic properties of the FeSe/STO interface from first-principle calculations
arXiv:1605.02244 · doi:10.1088/0953-2048/29/10/104005
Abstract
Compared to experiment, the calculated bulk lattice constant of FeSe is too small in LDA, PBEsol and PBE type exchange-correlation (xc) functionals even though the mismatch decreases from LDA to PBE. In bulk SrTiO3 (STO) on the other hand LDA over-binds, PBE under-binds and PBEsol agrees best with experiment. With the errors in opposite directions, the strain in the FeSe monolayer on STO depends on the xc functional and, especially in the non-magnetic state, is strongly overestimated. In this work we investigate the influence of the xc functional and magnetism in density functional calculations on electronic bonding properties and charge transfer in the FeSe monolayer on a STO substrate. Furthermore, we consider the effect of oxygen-vacancies within the virtual crystal approximation. In agreement with earlier work, we find that the band structure of the checkerboard antiferromagnetic configuration agrees best with experiment where, in addition, the relative strain on FeSe is best described. For a small vacancy concentration, in agreement with recent experiment, the FeSe monolayer Ti layer distance increases while for higher concentrations it decreases.
arXiv commentInvited contribution Supercond. Sci. Technol.: Focus on Superconductivity in the 2D limit
References in corpus (25)
- Quantum ESPRESSO: a modular and open-source software project for quantum simulations of materials
- Restoring the density-gradient expansion for exchange in solids and surfaces
- Generalized gradient approximation for solids and their surfaces
- Unconventional sign-reversing superconductivity in LaFeAsO_(1-x)F_x
- Pseudopotentials for high-throughput DFT calculations
- LaFeAsOF: A low carrier density superconductor near itinerant magnetism
- Gap symmetry and structure of Fe-based superconductors
- Phase Diagram and High Temperature Superconductivity at 65 K in Tuning Carrier Concentration of Single-Layer FeSe Films
- Interfacial mode coupling as the origin of the enhancement of Tc in FeSe films on SrTiO3
- Electronic Origin of High Temperature Superconductivity in Single-Layer FeSe Superconductor
- Enhancement of superconducting transition temperature of FeSe by intercalation of a molecular spacer layer
- The challenge of unravelling magnetic properties in LaFeAsO
- Evolution of high-temperature superconductivity from low-Tc phase tuned by carrier concentration in FeSe thin flakes
- Similarities between structural distortions under pressure and chemical doping in superconducting BaFe2As2
- Plain s-wave superconductivity in single-layer FeSe on SrTiO3 probed by scanning tunneling microscopy
- Observation of Double-Dome Superconductivity in Potassium-Doped FeSe Thin Films
- Electric field-induced superconducting transition of insulating FeSe thin film at 35 K
- Electron pairing in the presence of incipient bands in iron-based superconductors
- Ab initio study of the two-dimensional metallic state at the surface of SrTiO3: importance of oxygen vacancies
- The role of double TiO2 layers at the interface of FeSe/SrTiO3 superconductors
- Ab initio Study of Cross-Interface Electron-Phonon Couplings in FeSe Thin Films on SrTiO and BaTiO
- Charge transfer and electron-phonon coupling in monolayer FeSe on Nb doped SrTiO
- van der Waals interaction in iron-chalcogenide superconductors
- Strain effects on electronic structure of the iron selenide superconductor
- Proposal for a bulk material based on a monolayer FeSe on SrTiO3 high-temperature superconductor