Mechanical Flip-Chip for Ultra-High Electron Mobility Devices
arXiv:1503.05086 · doi:10.1038/srep13494
Abstract
Electrostatic gates are of paramount importance for the physics of devices based on high-mobility two-dimensional electron gas (2DEG) since they allow depletion of electrons in selected areas. This field-effect gating enables the fabrication of a wide range of devices such as, for example, quantum point contacts (QPC), electron interferometers and quantum dots. To fabricate these gates, processing is usually performed on the 2DEG material, which is in many cases detrimental to its electron mobility. Here we propose an alternative process which does not require any processing of the 2DEG material other than for the ohmic contacts. This approach relies on processing a separate wafer that is then mechanically mounted on the 2DEG material in a flip-chip fashion. This technique proved successful to fabricate quantum point contacts on both GaAs/AlGaAs materials with both moderate and ultra-high electron mobility.
arXiv comment5 pages, 3 figures
References in corpus (10)
- Observation of the e/3 Fractionally Charged Laughlin Quasiparticles
- An Electronic Mach-Zehnder Interferometer
- An On-Demand Coherent Single Electron Source
- Tunable Non-local Spin Control in a Coupled Quantum Dot System
- Measurement of filling factor 5/2 quasiparticle interference: observation of charge e/4 and e/2 period oscillations
- Quantum Point Contacts
- The Role of Interactions in an Electronic Fabry-Perot Interferometer Operating in the Quantum Hall Effect Regime
- Dynamic response of isolated Aharonov-Bohm rings coupled to an electromagnetic resonator
- Fabry-Perot Interferometry with Fractional Charges
- Fractional quantum Hall effect in a quantum point contact at filling fraction 5/2