Hydraulic External Pre-Isolator System for LIGO
arXiv:1309.5685 · doi:10.1088/0264-9381/31/23/235001
Abstract
The Hydraulic External Pre-Isolator (HEPI) is the first 6 degrees of freedom active seismic isolation system implemented at the Laser Interferometer Gravitational Wave Observatory (LIGO). Implementation was first completed at the LIGO Livingston Observatory (LLO) prior to LIGO's 5th science run, successfully cutting down the disturbance seen by LLO's suspended optics in the two most prominent seismic disturbance bands, the microseism (0.1-0.3Hz) and the anthropogenic (1-3Hz) bands, by a factor of a few to tens. The improvement in seismic isolation contributed directly to LLO's much improved duty cycle of 66.7% and LIGO's triple coincident duty cycle of 53%. We report the design, control scheme, and isolation performance of HEPI at LLO in this paper. Aided with this success, funding for incorporating HEPI into the LIGO Hanford Observatory was approved and installation is currently underway.
arXiv commentThis paper has been withdrawn by the author due to revisions
References in corpus (4)
Cited by in corpus (8)
- GW150914: The Advanced LIGO Detectors in the Era of First Discoveries
- Open data from the first and second observing runs of Advanced LIGO and Advanced Virgo
- Sensitivity and Performance of the Advanced LIGO Detectors in the Third Observing Run
- Seismic isolation of Advanced LIGO: Review of strategy, instrumentation and performance
- A Cryogenic Silicon Interferometer for Gravitational-wave Detection
- Advanced LIGO detector performance in the fourth observing run
- Review of the Advanced LIGO gravitational wave observatories leading to observing run four
- LIGO Detector Characterization in the first half of the fourth Observing run