Thin n-in-p pixel sensors and the SLID-ICV vertical integration technology for the ATLAS upgrade at the HL-LHC
arXiv:1210.7933 · doi:10.1016/j.nima.2013.04.077
Abstract
The R&D activity presented is focused on the development of new modules for the upgrade of the ATLAS pixel system at the High Luminosity LHC (HL-LHC). The performance after irradiation of n-in-p pixel sensors of different active thicknesses is studied, together with an investigation of a novel interconnection technique offered by the Fraunhofer Institute EMFT in Munich, the Solid-Liquid-InterDiffusion (SLID), which is an alternative to the standard solder bump-bonding. The pixel modules are based on thin n-in-p sensors, with an active thickness of 75 um or 150 um, produced at the MPI Semiconductor Laboratory (MPI HLL) and on 100 um thick sensors with active edges, fabricated at VTT, Finland. Hit efficiencies are derived from beam test data for thin devices irradiated up to a fluence of 4e15 neq/cm^2. For the active edge devices, the charge collection properties of the edge pixels before irradiation is discussed in detail, with respect to the inner ones, using measurements with radioactive sources. Beyond the active edge sensors, an additional ingredient needed to design four side buttable modules is the possibility of moving the wire bonding area from the chip surface facing the sensor to the backside, avoiding the implementation of the cantilever extruding beyond the sensor area. The feasibility of this process is under investigation with the FE-I3 SLID modules, where Inter Chip Vias are etched, employing an EMFT technology, with a cross section of 3 um x 10 um, at the positions of the original wire bonding pads.
arXiv commentProceedings for Pixel 2012 Conference, submitted to NIM A, 6 pages
References in corpus (6)
- Prototype ATLAS IBL Modules using the FE-I4A Front-End Readout Chip
- Performance of novel silicon n-in-p planar Pixel Sensors
- Recent Results of the ATLAS Upgrade Planar Pixel Sensors R&D Project
- Characterization of Thin Pixel Sensor Modules Interconnected with SLID Technology Irradiated to a Fluence of 2\,n/cm
- Recent results of the ATLAS Upgrade Planar Pixel Sensors R&D Project
- Novel Silicon n-in-p Pixel Sensors for the future ATLAS Upgrades
Cited by in corpus (7)
- Development of Edgeless n-on-p Planar Pixel Sensors for future ATLAS Upgrades
- Development of active edge pixel sensors and four-side buttable modules using vertical integration technologies
- Heavily Irradiated N-in-p Thin Planar Pixel Sensors with and without Active Edges
- Recent Results of the ATLAS Upgrade Planar Pixel Sensors R&D Project
- Development of Edgeless Silicon Pixel Sensors on p-type substrate for the ATLAS High-Luminosity Upgrade
- Production and Characterisation of SLID Interconnected n-in-p Pixel Modules with 75 Micrometer Thin Silicon Sensors
- Achievements of the ATLAS Upgrade Planar Pixel Sensors R&D Project