Recent Results of the ATLAS Upgrade Planar Pixel Sensors R&D Project
arXiv:1210.7661 · doi:10.1016/j.nima.2013.05.009
Abstract
To cope with the higher occupancy and radiation damage at the HL-LHC also the LHC experiments will be upgraded. The ATLAS Planar Pixel Sensor R&D Project (PPS) is an international collaboration of 17 institutions and more than 80 scientists, exploring the feasibility of employing planar pixel sensors for this scenario. Depending on the radius, different pixel concepts are investigated using laboratory and beam test measurements. At small radii the extreme radiation environment and strong space constraints are addressed with very thin pixel sensors active thickness in the range of (75-150) mum, and the development of slim as well as active edges. At larger radii the main challenge is the cost reduction to allow for instrumenting the large area of (7-10) m^2. To reach this goal the pixel productions are being transferred to 6 inch production lines and more cost-efficient and industrialised interconnection techniques are investigated. Additionally, the n-in-p technology is employed, which requires less production steps since it relies on a single-sided process. Recent accomplishments obtained within the PPS are presented. The performance in terms of charge collection and efficiency, obtained with radioactive sources in the laboratory and at beam tests, is presented for devices built from sensors of different vendors connected to either the present ATLAS chip FE-I3 or the new Insertable B-Layer chip FE-I4. The devices, with a thickness varying between 75 mum and 300 mum, were irradiated to several fluences up to 2e16 neq/cm. Finally, the different approaches followed inside the collaboration to achieve slim or active edges are presented.
arXiv commentProceedings for the Pixel 2012, 7 pages, 6 figures, accepted by NIM A
References in corpus (10)
- Prototype ATLAS IBL Modules using the FE-I4A Front-End Readout Chip
- Thin n-in-p pixel sensors and the SLID-ICV vertical integration technology for the ATLAS upgrade at the HL-LHC
- Development of Edgeless n-on-p Planar Pixel Sensors for future ATLAS Upgrades
- Planar Pixel Sensors for the ATLAS Upgrade: Beam Tests results
- Test Beam Results of 3D Silicon Pixel Sensors for the ATLAS upgrade
- Performance of novel silicon n-in-p planar Pixel Sensors
- Characterization of new hybrid pixel module concepts for the ATLAS Insertable B-Layer upgrade
- Novel Silicon n-on-p Edgeless Planar Pixel Sensors for the ATLAS upgrade
- Characterization of Thin Pixel Sensor Modules Interconnected with SLID Technology Irradiated to a Fluence of 2\,n/cm
- Novel Silicon n-in-p Pixel Sensors for the future ATLAS Upgrades