Time and Amplitude of Afterpulse Measured with a Large Size Photomultiplier Tube
arXiv:0911.5336 · doi:10.1016/j.nima.2010.11.095
Abstract
We have studied the afterpulse of a hemispherical photomultiplier tube for an upcoming reactor neutrino experiment. The timing, the amplitude, and the rate of the afterpulse for a 10 inch photomultiplier tube were measured with a 400 MHz FADC up to 16 \ms time window after the initial signal generated by an LED light pulse. The time and amplitude correlation of the afterpulse shows several distinctive groups. We describe the dependencies of the afterpulse on the applied high voltage and the amplitude of the main light pulse. The present data could shed light upon the general mechanism of the afterpulse.
11 figures
References in corpus (2)
Cited by in corpus (17)
- Observation of Coherent Elastic Neutrino-Nucleus Scattering
- Calibration and Characterization of the IceCube Photomultiplier Tube
- Observation of Energy and Baseline Dependent Reactor Antineutrino Disappearance in the RENO Experiment
- Measurement of Reactor Antineutrino Oscillation Amplitude and Frequency at RENO
- Spectral Measurement of the Electron Antineutrino Oscillation Amplitude and Frequency using 500 Live Days of RENO Data
- Search for a Non-Relativistic Component in the Spectrum of Cosmic Rays at Earth
- Mass Testing and Characterization of 20-inch PMTs for JUNO
- Qualification Tests of the R11410-21 Photomultiplier Tubes for the XENON1T Detector
- The JSNS^2 Detector
- In-situ calibration of the single-photoelectron charge response of the IceCube photomultiplier tubes
- Novel technique for supernova detection with IceCube
- Search for Sub-eV Sterile Neutrino at RENO
- Performance evaluation of the 8-inch MCP-PMT for Jinping Neutrino Experiment
- Calibration of the IceCube Neutrino Observatory
- Measurement of cosmogenic Li and He production rates at RENO
- Sterile Neutrino Searches at the IceCube Neutrino Observatory
- Characterization of the Hamamatsu 8-inch R14688-100 PMT