Anomalies in thickness measurements of graphene and few layer graphite crystals by tapping mode atomic force microscopy

Abstract

Atomic Force Microscopy (AFM) in the tapping (intermittent contact) mode is a commonly used tool to measure the thickness of graphene and few layer graphene (FLG) flakes on silicon oxide surfaces. It is a convenient tool to quickly determine the thickness of individual FLG films. However, reports from literature show a large variation of the measured thickness of graphene layers. This paper is focused on the imaging mechanism of tapping mode AFM (TAFM) when measuring graphene and FLG thickness and we show that at certain measurement parameters significant deviations can be introduced in the measured thickness of FLG flakes. An increase of as much as 1 nm can be observed in the measured height of FLG crystallites, when using an improperly chosen range of free amplitude values of the tapping cantilever. We present comparative Raman spectroscopy and TAFM measurements on selected single and multilayer graphene films, based on which we suggest ways to correctly measure graphene and FLG thickness using TAFM.

References in corpus (11)

• Electric Field Effect in Atomically Thin Carbon Films
• The Raman Fingerprint of Graphene
• Two Dimensional Atomic Crystals
• Detection of Individual Gas Molecules Absorbed on Graphene
• Unconventional quantum Hall effect and Berry's phase of 2pi in bilayer graphene
• Making graphene visible
• Graphene Nano-Ribbon Electronics
• Bipolar supercurrent in graphene
• Rayleigh Imaging of Graphene and Graphene Layers
• High-Resolution Scanning Tunneling Microscopy Imaging of Mesoscopic Graphene Sheets on an Insulating Surface
• Colors Of Graphite On Silicon Dioxide