Model for monitoring of a charge qubit using a radio-frequency quantum point contact including experimental imperfections
arXiv:0706.3527 · doi:10.1103/PhysRevB.77.125304
Abstract
The extension of quantum trajectory theory to incorporate realistic imperfections in the measurement of solid-state qubits is important for quantum computation, particularly for the purposes of state preparation and error-correction as well as for readout of computations. Previously this has been achieved for low-frequency (dc) weak measurements. In this paper we extend realistic quantum trajectory theory to include radio frequency (rf) weak measurements where a low-transparency quantum point contact (QPC), coupled to a charge qubit, is used to damp a classical oscillator circuit. The resulting realistic quantum trajectory equation must be solved numerically. We present an analytical result for the limit of large dissipation within the oscillator (relative to the QPC), where the oscillator slaves to the qubit. The rf+dc mode of operation is considered. Here the QPC is biased (dc) as well as subjected to a small-amplitude sinusoidal carrier signal (rf). The rf+dc QPC is shown to be a low-efficiency charge-qubit detector, that may nevertheless be higher than the dc-QPC (which is subject to 1/f noise).
arXiv comment12 pages, 2 colour figures. v3 is published version (minor changes since v2)
References in corpus (37)
- Quantum Computation with Quantum Dots
- Electron Spin Resonance Transistors for Quantum Computing in Silicon-Germanium Heterostructures
- Coherent manipulation of electronic states in a double quantum dot
- Feedback-control of quantum systems using continuous state-estimation
- Charge-qubit operation of an isolated double quantum dot
- Quantum feedback control and classical control theory
- Adaptive homodyne measurement of optical phase
- Continuous quantum measurement of a double dot
- Fast Single-Charge Sensing with an rf Quantum Point Contact
- Quantum trajectory approach to circuit QED: Quantum jumps and the Zeno effect
- Quantum Trajectories and Quantum Measurement Theory
- Selective quantum evolution of a qubit state due to continuous measurement
- Quantum Computation in Quantum-Hall Systems
- Continuous quantum measurement of two coupled quantum dots using a point contact: A quantum trajectory approach
- Bayesian feedback versus Markovian feedback in a two-level atom
- Dynamics of a mesoscopic qubit under continuous quantum measurement
- Capture and release of a conditional state of a cavity QED system by quantum feedback
- Linear stochastic wave-equations for continuously measured quantum systems
- State and dynamical parameter estimation for open quantum systems
- How to project qubits faster using quantum feedback
- Quantum feedback control of a solid-state qubit
- Quantum error correction for continuously detected errors
- A practical scheme for error control using feedback
- Counting statistics and detector properties of quantum point contacts
- Charge noise analysis of an AlGaAs/GaAs quantum dot using transmission-type radio-frequency single-electron transistor technique
- Continuous quantum measurement: inelastic tunnelling suppresses current oscillations
- Quantum Trajectories for Realistic Photodetection I: General Formalism
- Sensitivity and back-action in charge qubit measurements by a strongly coupled single-electron transistor
- Quantum Trajectories for Realistic Detection
- Nonideal quantum detectors in Bayesian formalism
- Quantum measurement of coherence in coupled quantum dots
- Quantum error correction for continuously detected errors with any number of error channels per qubit
- Quantum trajectories for the realistic measurement of a solid-state charge qubit
- Monte Carlo Method for a Quantum Measurement Process by a Single-Electron Transistor
- Stochastic simulations of conditional states of partially observed systems, quantum and classical
- Correlated quantum measurement of a solid-state qubit
- Numerical analysis of the radio-frequency single-electron transistor operation
Cited by in corpus (13)
- Introduction to Quantum Noise, Measurement and Amplification
- Qubit models of weak continuous measurements
- Scanning Quantum Decoherence Microscopy
- Rapid purification of quantum systems by measuring in a feedback-controlled unbiased basis
- Stochastic Bloch-Redfield theory: quantum jumps in a solid-state environment
- Maintaining Quantum Coherence in the Presence of Noise through State Monitoring
- Quantum Control through a Self-Fulfilling Prophecy
- Monitoring the wave function by time continuous position measurement
- Continuous Quantum Error Correction Through Local Operations
- Robust control of quantum systems by quantum systems
- Equation of Motion for Estimation Fidelity of Monitored Oscillating Qubits
- Rapid readout of a register of qubits using open loop quantum control
- Double detected spin-dependent quantum dot