741 citations · 4.6k across the 164 of their papers we have counts for
8 papers · 1 filter
Beam-induced backgrounds measured in the ATLAS detector during local gas injection into the LHC beam vacuum
ATLAS Collaboration
Inelastic beam-gas collisions at the Large Hadron Collider (LHC), within a few hundred metres of the ATLAS experiment, are known to give the dominant contribution to beam backgroun…
Improving topological cluster reconstruction using calorimeter cell timing in ATLAS
ATLAS Collaboration
Clusters of topologically connected calorimeter cells around cells with large absolute signal-to-noise ratio (topo-clusters) are the basis for calorimeter signal reconstruction in…
The ATLAS Experiment at the CERN Large Hadron Collider: A Description of the Detector Configuration for Run 3
ATLAS Collaboration
The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of $\mathcal{L}=2\times 10^{34}\mathr…
The Cesium Source Calibration and Monitoring System of the ATLAS Tile Calorimeter: Design, Construction and Results
G. Blanchot, M. Bosman, J. Budagov +16
This article describes the design, construction and use of a calibration and monitoring system, based on movable 137Cs gamma-ray sources, for the ATLAS Tile Calorimeter (TileCal).…
ATLAS data quality operations and performance for 2015-2018 data-taking
ATLAS Collaboration
The ATLAS detector at the Large Hadron Collider reads out particle collision data from over 100 million electronic channels at a rate of approximately kHz, with a recording r…
A Layer Correlation technique for pion energy calibration at the 2004 ATLAS Combined Beam Test
E. Abat, J. M. Abdallah, T. N. Addy +482
A new method for calibrating the hadron response of a segmented calorimeter is developed and successfully applied to beam test data. It is based on a principal component analysis o…