activity
20152026
most citedATLAS data quality operations and performance for 2015-2018 data-taking

337 citations · 4.9k across the 148 of their papers we have counts for

collaborators
Showing physics.ins-detShow all

5 papers · 1 filter

physics.ins-det2024★ 2 cited

Beam-induced backgrounds measured in the ATLAS detector during local gas injection into the LHC beam vacuum

ATLAS Collaboration

Inelastic beam-gas collisions at the Large Hadron Collider (LHC), within a few hundred metres of the ATLAS experiment, are known to give the dominant contribution to beam backgroun…

physics.ins-det2023

Improving topological cluster reconstruction using calorimeter cell timing in ATLAS

ATLAS Collaboration

Clusters of topologically connected calorimeter cells around cells with large absolute signal-to-noise ratio (topo-clusters) are the basis for calorimeter signal reconstruction in…

physics.ins-det2023★ 44 cited

The ATLAS Experiment at the CERN Large Hadron Collider: A Description of the Detector Configuration for Run 3

ATLAS Collaboration

The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of $\mathcal{L}=2\times 10^{34}\mathr…

physics.ins-det2019★ 337 cited

ATLAS data quality operations and performance for 2015-2018 data-taking

ATLAS Collaboration

The ATLAS detector at the Large Hadron Collider reads out particle collision data from over 100 million electronic channels at a rate of approximately kHz, with a recording r…

physics.ins-det2016★ 27 cited

The Laser calibration of the Atlas Tile Calorimeter during the LHC run 1

ATLAS Tile Calorimeter system

This article describes the Laser calibration system of the Atlas hadronic Tile Calorimeter that has been used during the run 1 of the LHC. First, the stability of the system associ…