568 citations · 8k across the 255 of their papers we have counts for
9 papers · 1 filter
The ATLASPix3.1 CMOS Pixel Sensor Testbeam Performance and Serial Powering Characterisation
F. Ustuner, R. Zanzottera, A. Andreazza +8
High-voltage CMOS (HV-CMOS) pixel technology is being considered for future Higgs factory experiments. The ATLASPix3.1 chip, with a pitch of 50 x 150, fabricated using TSI…
Beam-induced backgrounds measured in the ATLAS detector during local gas injection into the LHC beam vacuum
ATLAS Collaboration
Inelastic beam-gas collisions at the Large Hadron Collider (LHC), within a few hundred metres of the ATLAS experiment, are known to give the dominant contribution to beam backgroun…
Improving topological cluster reconstruction using calorimeter cell timing in ATLAS
ATLAS Collaboration
Clusters of topologically connected calorimeter cells around cells with large absolute signal-to-noise ratio (topo-clusters) are the basis for calorimeter signal reconstruction in…
The ATLAS Experiment at the CERN Large Hadron Collider: A Description of the Detector Configuration for Run 3
ATLAS Collaboration
The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of $\mathcal{L}=2\times 10^{34}\mathr…
ATLAS data quality operations and performance for 2015-2018 data-taking
ATLAS Collaboration
The ATLAS detector at the Large Hadron Collider reads out particle collision data from over 100 million electronic channels at a rate of approximately kHz, with a recording r…
Production and Integration of the ATLAS Insertable B-Layer
B. Abbott, J. Albert, F. Alberti +373
During the shutdown of the CERN Large Hadron Collider in 2013-2014, an additional pixel layer was installed between the existing Pixel detector of the ATLAS experiment and a new, s…
A Layer Correlation technique for pion energy calibration at the 2004 ATLAS Combined Beam Test
E. Abat, J. M. Abdallah, T. N. Addy +482
A new method for calibrating the hadron response of a segmented calorimeter is developed and successfully applied to beam test data. It is based on a principal component analysis o…
A Layer Correlation Technique for Pion Energy Calibration at the 2004 ATLAS Combined Beam Test
Karl-Johan Grahn
A new method for calibrating the hadron response of a segmented calorimeter is developed. It is based on a principal component analysis of the calorimeter layer energy deposits, ex…
Alignment of the Pixel and SCT Modules for the 2004 ATLAS Combined Test Beam
A. Ahmad, A. Andreazza, T. Atkinson +126
A small set of final prototypes of the ATLAS Inner Detector silicon tracker (Pixel and SCT) were used to take data during the 2004 Combined Test Beam. Data were collected from runs…