High quality factor measured in fused silica
arXiv:gr-qc/0009035 · doi:10.1063/1.1394183
Abstract
We have measured the mechanical dissipation in a sample of fused silica drawn into a rod. The sample was hung from a multiple-bob suspension, which isolated it from rubbing against its support, from recoil in the support structure, and from seismic noise. The quality factor, Q, was measured for several modes with a high value of 57 million found for mode number 2 at 726 Hz. This result is about a factor 2 higher than previous room temperature measurements. The measured Q was strongly dependent on handling, with a pristine flame-polished surface yielding a Q 3-4 times higher than a surface which had been knocked several times against a copper tube.
arXiv commentPreprint - Under review by LSC publications committee
References in corpus (3)
Cited by in corpus (12)
- Thermal noise in interferometric gravitational wave detectors due to dielectric optical coatings
- Mechanical Loss in Tantala/Silica Dielectric Mirror Coatings
- Frequency and surface dependence of the mechanical loss in fused silica
- Very high quality factor measured in annealed fused silica
- Measurement of the mechanical loss of a cooled reflective coating for gravitational wave detection
- Systematic measurement of the intrinsic losses in various kinds of bulk fused silica
- Comparison of advanced gravitational-wave detectors
- Constraining modified gravity with quantum optomechanics
- Effects of electrical charging on the mechanical Q of a fused silica disk
- Superfluid Optomechanics with Phononic Nanostructures
- Mechanical Characterisation of Silicon for the ETpathfinder Test Masses
- Cordierite-based optical resonators with extremely low thermal expansion