Coronal electron density: Insights from radio and in situ observations, and EUHFORIA modeling

Abstract

The distribution of the coronal electron density at different distances from the Sun strongly influences the physical processes in the solar corona and is therefore a very important topic in solar physics. Most methods, including radio observations, used for estimating coronal electron density were not fully validated due to the absence of in situ observations closer to the Sun. Consequently, space weather forecasting models that simulate coronal density lacked proper validation. Newly available PSP in situ observations at distances close to the Sun provide an opportunity to study plasma properties near the Sun and to compare observational and modeling results. This work studies type III bursts, estimates their propagation path, and validates coronal electron density obtained from radio, in situ observations, and modeling with EUHFORIA. Type III bursts observed during the second PSP perihelion are analyzed using radio triangulation and modeling. We determine 3D positions of radio sources and use EUHFORIA to estimate electron densities at various locations. The electron densities derived from radio observations and EUHFORIA modeling are inter-validated with in situ PSP measurements. We studied 11 type III bursts during the second PSP perihelion, with radio triangulation showing propagation paths southward from the solar ecliptic plane. Radio source sizes ranged from 0.5 to 40 deg (0.5 to 25 Rs) with no clear frequency dependence, indicating that scattering of radio waves was not very significant. Comparison of electron densities from radio triangulation, PSP data, and EUHFORIA modeling showed a large range of values, influenced by different propagation paths and model limitations. Despite these variations, EUHFORIA identified high-density regions along type III burst paths.

20 pages, 16 figures, 1 table, Accepted in A&A journal

References in corpus (19)

• The Solar Orbiter mission -- Science overview
• Advancements in the ADAPT Photospheric Flux Transport Model
• JHelioviewer - Time-dependent 3D visualisation of solar and heliospheric data
• First in-situ Measurements of Electron Density and Temperature from Quasi-Thermal Noise Spectroscopy with Parker Solar Probe/FIELDS
• Verification of high-speed solar wind stream forecasts using operational solar wind models
• Density Fluctuations in the Solar Wind Based on Type III Radio Bursts Observed by Parker Solar Probe
• Statistics and Polarization of Type III Radio Bursts Observed in the Inner Heliosphere
• The Highly Collimated Radio Jet of HH 80-81: Structure and Non-Thermal Emission
• Coronal Magnetic Field Topology From Total Solar Eclipse Observations
• Statistical Survey of Type III Radio Bursts at Long Wavelengths Observed by the Solar TErrestrial RElations Observatory (STEREO)/Waves Instruments: Radio Flux Density Variations with Frequency
• Implementation and validation of the FRi3D flux rope model in EUHFORIA
• Forecasting the Ambient Solar Wind with Numerical Models: I. On the Implementation of an Operational Framework
• Implementing the MULTI-VP coronal model in EUHFORIA: test case results and comparisons with the WSA coronal model
• Autoplot: A browser for scientific data on the web
• Statistical Survey of Type III Radio Bursts at Long Wavelengths Observed by the Solar TErrestrial RElations Observatory (STEREO)/Waves Instruments: Goniopolarimetric Properties and Radio Source Locations
• Using radio triangulation to understand the origin of two subsequent type II radio bursts
• CME liftoff with high-frequency fragmented type II burst emission
• Forward Modeling of the Type III Radio Burst Exciter
• Tracking solar radio bursts using Bayesian multilateration