Characterization of process-related interfacial dielectric loss in aluminum-on-silicon by resonator microwave measurements, materials analysis, and imaging

Abstract

We systematically investigate the influence of the fabrication process on dielectric loss in aluminum-on-silicon superconducting coplanar waveguide resonators with internal quality factors ($Q_i$) of about one million at the single-photon level. These devices are essential components in superconducting quantum processors; they also serve as proxies for understanding the energy loss of superconducting qubits. By systematically varying several fabrication steps, we identify the relative importance of reducing loss at the substrate-metal and the substrate-air interfaces. We find that it is essential to clean the silicon substrate in hydrogen fluoride (HF) prior to aluminum deposition. A post-fabrication removal of the oxides on the surface of the silicon substrate and the aluminum film by immersion in HF further improves the $Q_i$. We observe a small, but noticeable, adverse effect on the loss by omitting either standard cleaning (SC1), pre-deposition heating of the substrate to 300$°$C, or in-situ post-deposition oxidation of the film's top surface. We find no improvement due to excessive pumping meant to reach a background pressure below $6\times 10^{-8}$ mbar. We correlate the measured loss with microscopic properties of the substrate-metal interface through characterization with X-ray photoelectron spectroscopy (XPS), time-of-flight secondary ion mass spectroscopy (ToF-SIMS), transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS), and atomic force microscopy (AFM).

22 pages, 11 figures

References in corpus (16)

• Experimental evidence for a surface distribution of two-level systems in superconducting lithographed microwave resonators
• Decoherence benchmarking of superconducting qubits
• Efficient and robust analysis of complex scattering data under noise in microwave resonators
• Microwave Dielectric Loss at Single Photon Energies and milliKelvin Temperatures
• Reducing intrinsic loss in superconducting resonators by surface treatment and deep etching of silicon substrates
• Minimal resonator loss for circuit quantum electrodynamics
• Characterization and Reduction of Capacitive Loss Induced by Sub-Micron Josephson Junction Fabrication in Superconducting Qubits
• Systematic Improvements in Transmon Qubit Coherence Enabled by Niobium Surface Encapsulation
• Simplified Josephson-junction fabrication process for reproducibly high-performance superconducting qubits
• Disentangling Losses in Tantalum Superconducting Circuits
• Wirebond crosstalk and cavity modes in large chip mounts for superconducting qubits
• Precision measurement of the microwave dielectric loss of sapphire in the quantum regime with parts-per-billion sensitivity
• TOF-SIMS Analysis of Decoherence Sources in Nb Superconducting Resonators
• Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits
• Nitrogen Plasma Passivated Niobium Resonators for Superconducting Quantum Circuits
• Low-Loss Superconducting Nanowire Circuits Using a Neon Focused Ion Beam

Cited by in corpus (3)

• Signal crosstalk in a flip-chip quantum processor
• In-situ tunable interaction with an invertible sign between a fluxonium and a post cavity
• Surface Optimization of Superconducting Aluminum Resonators for Robust Quantum Device Fabrication