Low-frequency pulse-jitter measurement with the uGMRT I : PSR J0437$-$4715

Abstract

High-precision pulsar timing observations are limited in their accuracy by the jitter noise that appears in the arrival time of pulses. Therefore, it is important to systematically characterise the amplitude of the jitter noise and its variation with frequency. In this paper, we provide jitter measurements from low-frequency wideband observations of PSR J0437$-$4715 using data obtained as part of the Indian Pulsar Timing Array experiment. We were able to detect jitter in both the 300 - 500 MHz and 1260 - 1460 MHz observations of the upgraded Giant Metrewave Radio Telescope (uGMRT). The former is the first jitter measurement for this pulsar below 700 MHz, and the latter is in good agreement with results from previous studies. In addition, at 300 - 500 MHz, we investigated the frequency dependence of the jitter by calculating the jitter for each sub-banded arrival time of pulses. We found that the jitter amplitude increases with frequency. This trend is opposite as compared to previous studies, indicating that there is a turnover at intermediate frequencies. It will be possible to investigate this in more detail with uGMRT observations at 550 - 750 MHz and future high sensitive wideband observations from next generation telescopes, such as the Square Kilometre Array. We also explored the effect of jitter on the high precision dispersion measure (DM) measurements derived from short duration observations. We find that even though the DM precision will be better at lower frequencies due to the smaller amplitude of jitter noise, it will limit the DM precision for high signal-to-noise observations, which are of short durations. This limitation can be overcome by integrating for a long enough duration optimised for a given pulsar.

arXiv comment13 pages, 12 figures, 3 tables, accepted for Publication of the Astronomical Society of Australia

References in corpus (19)

• emcee: The MCMC Hammer
• TEMPO2, a new pulsar timing package. I: Overview
• PSRCHIVE and PSRFITS An Open Approach to Radio Pulsar Data Storage and Analysis
• Tempo2, a new pulsar timing package. II: The timing model and precision estimates
• DSPSR: Digital Signal Processing Software for Pulsar Astronomy
• The North American Nanohertz Observatory for Gravitational Waves
• Assessing the Role of Spin Noise in the Precision Timing of Millisecond Pulsars
• The Parkes Pulsar Timing Array
• TempoNest: A Bayesian approach to pulsar timing analysis
• New advances in the Gaussian-process approach to pulsar-timing data analysis
• Measuring the mass of solar system planets using pulsar timing
• High signal-to-noise ratio observations and the ultimate limits of precision pulsar timing
• Radio Pulse Properties of the Millisecond Pulsar PSR J0437-4715. I. Observations at 20cm
• Pulse intensity modulation and the timing stability of millisecond pulsars: A case study of PSR J1713+0747
• Timing, polarimetry and physics of the bright, nearby millisecond pulsar PSR J0437-4715 - a single-pulse perspective
• Fourier domain excision of periodic radio frequency interference
• Detection of polarized quasi-periodic microstructure emission in millisecond pulsars
• A population-based Habitable Zone perspective
• Time-scales of Radio Emission in PSR J0437-4715 at 327 MHz

Cited by in corpus (2)

• The Indian Pulsar Timing Array Data Release 2: II. Customised Single-Pulsar Noise Analysis and Noise Budget
• Revisiting wideband pulsar timing measurements