paper

Sky location of Galactic white dwarf binaries in space-based gravitational wave detection

arXiv:2310.16796 · doi:10.1016/j.rinp.2024.107607

Abstract

Quickly localizing the identified white dwarf (WD) binaries is the basic requirement for the space-based gravitational wave (GW) detection. In fact, the amplitude of GW signals are modulated by the periodic motion of GW detectors on the solar orbit. The intensity of the observed signals is enhanced according to the observation time beyond a year to enhance a high signal to noise ratio (SNR). As data gap exists, the completeness of the data observed for a long time depends on filling gaps in the data. Actually, in a year period, the GW sources have a best observation orbit position of GW detectors, where the detector response intensity of GW is maximum. Thus, the best positions, where the direction of GW source is perpendicular to the detection arms, can be searched for the verified GW sources of the sky map to enhance SNR too. For the three arms response intensity of the GW signals changing more clearly with the location of the GW sources relative to the detector, the noises and the suppression of noise by time delay interferometer are ignored. In the four chosen sources, the two verification WD binaries: J0806 and V407 Vul are observed at the best orbit positions by TAIJI for the short time of 2 and 3 days respectively. The intensities of those GWs are above the values of the TAIJI sensitivity curve, significantly. Compared with a single detector, the network of two detectors does not significantly improve the accuracy of location of the verification binaries. These results imply that the searching of GW signals and parameter estimation of GW sources from the experimental data of the space-based mission do not ignore the orbit positions relevant to GW sources.

arXiv comment22 pages, 15 figures

References in corpus (38)

Cited by in corpus (1)