Continuous reset element: Transient and steady-state analysis for precision motion systems
arXiv:2110.12801 · doi:10.1016/j.conengprac.2022.105232
Abstract
This paper addresses the main goal of using reset control in precision motion control systems, breaking of the well-known "Waterbed effect". A new architecture for reset elements will be introduced which has a continuous output signal as opposed to conventional reset elements. A steady-state precision study is presented, showing the steady-state precision is preserved while the peak of sensitivity is reduced. The architecture is then used for a "Constant in Gain Lead in Phase" (CgLp) element and a numerical analysis on transient response shows a significant improvement in transient response. It is shown that by following the presented guideline for tuning, settling time can be reduced and at the same time a non-overshoot step response can be achieved. A practical example is presented to verify the results and also to show that the proposed element can achieve a complex-order behaviour.
References in corpus (8)
- 'Constant in gain Lead in phase' element - Application in precision motion control
- Loop-shaping for reset control systems -- A higher-order sinusoidal-input describing functions approach
- The optimal sequence for reset controllers
- Fractional-Order Single State Reset Element
- A Frequency-Domain Stability Method for Reset Systems
- Tuning of Constant in gain Lead in phase (CgLp) Reset Controller using higher-order sinusoidal input describing function (HOSIDF)
- Band-Passing Nonlinearity in Reset Elements
- Benefiting from Linear Behaviour of a Nonlinear Reset-based Element at Certain Frequencies