Measurement of at the 250 GeV ILC
arXiv:2108.08867 · doi:10.1103/PhysRevD.104.093007
Abstract
We report on studies of the process with the subsequent decay of the Higgs boson , where the combination is reconstructed in the final states with two jets and two leptons. The analysis is performed using Monte Carlo data samples obtained with detailed ILD detector simulation assuming the integrated luminosity 2 ab, the beam polarizations , and the center-of-mass energy = 250 GeV. The analysis is also repeated for the case of two 0.9 ab data samples with polarizations . The process is measured in four decay channels, which correspond to two combinations for the Higgs final states and two decay modes of the directly produced boson, and . To obtain the Higgs boson mass distributions, we used the variables and , where = 91.2 GeV. Contributions of the potential background processes are taken into account based on the available MC event samples. We propose a model-independent method for obtaining the width of the Higgs boson using the measurement of the process.
9 pages, 6 figures, 5 tables, published in Phys. Rev. D
References in corpus (5)
- Observation of a new particle in the search for the Standard Model Higgs boson with the ATLAS detector at the LHC
- Observation of a new boson at a mass of 125 GeV with the CMS experiment at the LHC
- PYTHIA 6.4 Physics and Manual
- Model Independent Determination of coupling and Higgs total width at ILC
- Prospects of measuring the branching fraction of the Higgs boson decaying into muon pairs at the International Linear Collider