Characterisation of Cryogenic Material Properties of 3D-Printed Superconducting Niobium using a 3D Lumped Element Microwave Cavity

Abstract

We present an experimental characterisation of the electrical properties of 3D-printed Niobium. The study was performed by inserting a 3D-printed Nb post inside an Aluminium cylindrical cavity, forming a 3D lumped element re-entrant microwave cavity resonator. The resonator was cooled to temperatures below the critical temperature of Niobium (9.25K) and then Aluminium (1.2K), while measuring the quality factors of the electromagnetic resonances. This was then compared with finite element analysis of the cavity and a measurement of the same cavity with an Aluminium post of similar dimensions and frequency, to extract the surface resistance of the Niobium post. The 3D-printed Niobium exhibited a transition to the superconducting state at a similar temperature to the regular Niobium, as well as a surface resistance of $3.1\times 10^{-4}$ $\Omega$. This value was comparable to many samples of traditionally machined Niobium previously studied without specialised surface treatment. Furthermore, this study demonstrates a simple new method for characterizing the material properties of a relatively small and geometrically simple sample of superconductor, which could be easily applied to other materials, particularly 3D-printed materials. Further research and development in additive manufacturing may see the application of 3D-printed Niobium in not only superconducting cavity designs, but in the innovative technology of the future.

arXiv comment5 pages, 4 figures

References in corpus (21)

• Observation of high coherence in Josephson junction qubits measured in a three-dimensional circuit QED architecture
• The Low-Energy Frontier of Particle Physics
• A New Limit on Signals of Lorentz Violation in Electrodynamics
• Direct Terrestrial Test of Lorentz Symmetry in Electrodynamics to 10${}^{-18}$
• Surface impedance and optimum surface resistance of a superconductor with imperfect surface
• Field-dependent nonlinear surface resistance and its optimization by surface nano-structuring in superconductors
• Rigorous analysis of highly tunable cylindrical Transverse Magnetic mode re-entrant cavities
• Cryogenic resonant microwave cavity searches for hidden sector photons
• A 3D Printed Superconducting Aluminium Microwave Cavity
• Axion Detection with Precision Frequency Metrology
• UPconversion Loop Oscillator Axion Detection experiment: A precision frequency interferometric axion dark matter search with a Cylindrical Microwave Cavity
• 3D Lumped LC Resonators as Low Mass Axion Haloscopes
• Dissipative conductivity of a dirty superconductor with Dynes subgap states under a dc bias current up to the depairing current density
• Resonant Regeneration in the Sub-Quantum Regime -- A demonstration of fractional quantum interference
• Hidden Sector Photon Coupling of Resonant Cavities
• Piezoelectric Voltage Coupled Reentrant Cavity Resonator
• Higher Order Reentrant Post Modes in Cylindrical Cavities
• Microwave cavity hidden sector photon threshold crossing
• Surface impedance measurements on Nb${}_3$Sn at high magnetic fields
• Creating Tuneable Microwave Media from a Two-Dimensional Lattice of Re-entrant Posts
• High-Kinetic Inductance Additive Manufactured Superconducting Microwave Cavity

Cited by in corpus (4)

• Searching for Ultra-Light Axions with Twisted Cavity Resonators of Anyon Rotational Symmetry with Bulk Modes of Non-Zero Helicity
• Metallised 3D printed plastic resonator demonstrates superconductivity below 4 K
• Conductivity Freeze-Out in Isotopically Pure Si-28 at milli-Kelvin Temperatures
• Power Dependent Resonant Frequency of a Microwave Cavity due to Magnetic Levitation