Relationship Between Macrostep Height and Surface Velocity for a Reaction-Limited Crystal Growth Process
arXiv:1903.09929
Abstract
This work examined the effect of macrostep height on the growth velocity of a vicinal surface during reaction- (interface-) limited crystal growth under non-equilibrium steady state conditions. The Monte Carlo method was employed, based on a restricted solid-on-solid (RSOS) model with point-contact-type step-step attraction (termed the p-RSOS model). Although this is a simple lattice model, the model surface shows a variety of distinctive configurations depending on the temperature and the driving force for crystal growth. The results demonstrate that the surface velocity decreases as the height of the faceted macrostep increases. In addition, the significant variation in surface velocity recently reported by Onuma {\it et al.} in a study based on 4H-SiC was reproduced. This work also shows that the terrace slope, elementary step velocity and elementary step kinetic coefficient are all affected by the faceted macrostep height.
arXiv comment11pages, 12 figures. This manuscript was prepared for the achesmo (a latex package for the ACS). Since the achesmo is not supported, this manuscript was converted to RevTeX. This manuscript is submitted to the Crystal Growth & Design
References in corpus (9)
- The density-matrix renormalization group
- Density Matrix Renormalization Group Method for 2D Classical Models
- Product Wave Function Renormalization Group Method
- Magnetization Process of One-Dimensional Quantum Antiferromagnet: The Product Wavefunction Renormalization Group Approach
- Numerical Renormalization Approach to Two-Dimensional Quantum Antiferromagnets with Valence-Bond-Solid Type Ground State
- Sticky steps inhibit step motions near equilibrium
- Phase diagram of step faceting for sticky steps
- Step bunching and macrostep formation in 1D atomistic scale model of unstable vicinal crystal growth
- Height of a faceted macrostep for sticky steps in a step-faceting zone