High-Resolution Adiabatic Calorimetry of Supercooled Water
arXiv:1812.01085 · doi:10.1088/1742-6596/1385/1/012008
Abstract
Liquid water exhibits anomalous behavior in the supercooled region. A popular hypothesis to explain supercooled water's anomalies is the existence of a metastable liquid-liquid transition terminating at a critical point. The hypothesized phase transition is not directly accessible in a bulk experiment because it is expected to occur in "no-man's" region below the kinetic stability limit of the liquid phase at about 235 K, the temperature of homogeneous ice formation. Therefore, verifications of this hypothesis are usually based on extrapolations from the experimentally accessible region. In this work, we present the results of high-resolution adiabatic calorimetry measurements of cold and supercooled liquid water in the range from 294 to 244 K, the lowest temperature of water's supercooling achieved so far in a bulk adiabatic-calorimetry experiment. The resolution of the measurements is also record-high, with the average statistical (random) error of about 0.1 %. The data are consistent with adiabatic-calorimetry measurements of supercooled water earlier reported by Tombari et al. [Chem. Phys Lett., Vol. 300, P. 749 (1999)] but significantly deviate from differential-scanning calorimetry measurements in emulsified water reported by Angell et al. [J. Phys. Chem., Vol. 86, P. 998 (1982)] and by Archer and Carter [J. Phys. Chem B., Vol. 104, P. 8563 (2000)]. Consequences of the new heat-capacity data in interpretation of the nature of water's anomalies are discussed.
arXiv comment6 pages, 4 figures
References in corpus (5)
- Entropy-driven liquid-liquid separation in supercooled water
- Thermodynamics of supercooled water
- Nature of the anomalies in the supercooled liquid state of the mW model of water
- Equation of state for supercooled water at pressures up to 400 MPa
- A comprehensive scenario of the thermodynamic anomalies of water using the TIP4P/2005 model