Light yield and radiation hardness studies of scintillator strips with a filler
arXiv:1711.11393 · doi:10.1016/j.nima.2019.03.087
Abstract
Detectors based on polystyrene scintillator strips with WLS fiber readout are widely used to register charged particles in many high-energy physics experiments. The fibers are placed into grooves or holes along the strip. The detection efficiency of these devices can be significantly increased by improving the optical contact between the scintillator and the fiber by adding an optical filler into the groove/hole. This work is devoted to the study of the light yield of a 5-m-long scintillator strip with a 1.2-mm-diameter Kuraray Y11(200)~MC WLS fiber inserted into the strip's co-extruded hole filled with synthetic silicon resin SKTN-MED(E). The light yield was studied using cosmic muons and a Co radioactive source. Radiation hardness study of viscous fillers and short strip samples were performed on the IBR-2 pulsed research reactor of fast neutrons at JINR.
arXiv commentminor changes - authors sequence, added annotation on figure 9(b)
References in corpus (7)
- The T2K Experiment
- The magnetized steel and scintillator calorimeters of the MINOS experiment
- Scintillator detectors with long WLS fibers and multi-pixel photodiodes
- Optimization of light yield by injection of the optical filler into the co extruded hole of plastic scintillation bar with WLS fiber in it
- The "miniskirt" counter array at CDF-II
- The increase of the light collection from scintillation strip with hole for WLS fiber using various types of fillers
- Studies to Understand and Optimize the Performance of Scintillation Counters for the Mu2e Cosmic Ray Veto System