Conductance of graphene flakes contacted at their corners
arXiv:1509.05261 · doi:10.1088/0953-8984/27/43/435005
Abstract
Linear conductance of junctions formed by graphene flakes with order of nanometer-thick electrodes attached at the corners of the flakes is studied. The explored structures have sizes up to 20000 atoms and the conductance is studied as a function of applied gate voltage varied around the Fermi level. The finding, obtained computationally, is that junctions formed by armchair-edge flakes with the electrodes connected at the acute-angle corners block the electron transport while only junctions with such electrodes at the obtuse-angle corners tend to provide the high electrical conductance typical for metallic GNRs. The finding in case of zig-zag edges is similar with an exception of a relatively narrow gate voltage interval in which each studied junction is highly conductive as mediated by the edge states. The contrast between the conductive and insulating setups is typically several orders of magnitude in terms of ratio of their conductances. Main results of the paper remain to a large extent valid also in the presence of edge disorder.
22 pages, 14 figures, ancillary file with Supplementary Information. This is an author-created, un-copyedited version of an article published in J. Phys.: Condens. Matter. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it. The Version of Record is available online at http://dx.doi.org/10.1088/0953-8984/27/43/435005
References in corpus (7)
- The electronic properties of graphene
- Energy Gaps in Graphene Nanoribbons
- Quantum-limited shot noise in graphene
- Conductance quantization and transport gap in disordered graphene nanoribbons
- Dynamics of the particle - hole pair creation in graphene
- Spectrum of -electrons in Graphene As a Macromolecule
- Dual-probe spectroscopic fingerprints of defects in graphene