Fast Compact Laser Shutter Using a Direct Current Motor and 3D Printing

Abstract

We present a mechanical laser shutter design that utilizes a DC electric motor to rotate a blade which blocks and unblocks a light beam. The blade and the main body of the shutter are modeled with computer aided design (CAD) and are produced by 3D printing. Rubber flaps are used to limit the blade's range of motion, reducing vibrations and preventing undesirable blade oscillations. At its nominal operating voltage, the shutter achieves a switching speed of (1.22 $\pm$ 0.02) m/s with 1 ms activation delay and 10 $\mu$s jitter in its timing performance. The shutter design is simple, easy to replicate, and highly reliable, showing no failure or degradation in performance over more than $10^8$ cycles.

4 pages, 6 figures; supplementary materials for shutter replication added under "Ancillary files"

References in corpus (1)

• Fast Compact Laser Shutter Using a Direct Current Motor and 3D Printing

Cited by in corpus (5)

• Phonon counting thermometry of an ultracoherent membrane resonator near its motional ground state
• Fast Compact Laser Shutter Using a Direct Current Motor and 3D Printing
• A High-Performance, Low-Cost Laser Shutter using a Piezoelectric Cantilever Actuator
• Neutral Silicon Vacancy Centers in Diamond via Photoactivated Itinerant Carriers
• Servo-based light shutters with Arduino control