Performance of a Large-area GEM Detector Read Out with Wide Radial Zigzag Strips
arXiv:1508.07046 · doi:10.1016/j.nima.2015.11.157
Abstract
A 1-meter-long trapezoidal Triple-GEM detector with wide readout strips was tested in hadron beams at the Fermilab Test Beam Facility in October 2013. The readout strips have a special zigzag geometry and run along the radial direction with an azimuthal pitch of 1.37 mrad to measure the azimuthal phi-coordinate of incident particles. The zigzag geometry of the readout reduces the required number of electronic channels by a factor of three compared to conventional straight readout strips while preserving good angular resolution. The average crosstalk between zigzag strips is measured to be an acceptable 5.5%. The detection efficiency of the detector is (98.4+-0.2)%. When the non-linearity of the zigzag-strip response is corrected with track information, the angular resolution is measured to be (193+-3) urad, which corresponds to 14% of the angular strip pitch. Multiple Coulomb scattering effects are fully taken into account in the data analysis with the help of a stand-alone Geant4 simulation that estimates interpolated track errors.
30 pages, 28 figures, submitted to NIMA
References in corpus (2)
Cited by in corpus (7)
- A GEM readout with radial zigzag strips and linear charge-sharing response
- Design Studies for a TPC Readout Plane Using Zigzag Patterns with Multistage GEM Detectors
- A Study of a Mini-drift GEM Tracking Detector
- A Comparative Study of Straight-Strip and Zigzag-Interleaved Anode Patterns for MPGD Readouts
- Letter of Intent: the NA60+ experiment
- Accuracy of the geometric-mean method for determining spatial resolutions of tracking detectors in the presence of multiple Coulomb scattering
- R&D on GEM Detectors for Forward Tracking at a Future Electron-Ion Collider