A Comparison Study of a Solar Active-Region Eruptive Filament and a Neighboring Non-Eruptive Filament
arXiv:1508.05113 · doi:10.1088/1674-4527/16/1/018
Abstract
Solar active region (AR) 11283 is a very magnetically complex region and it has produced many eruptions. However, there exists a non-eruptive filament in the plage region just next to an eruptive one in the AR, which gives us an opportunity to perform a comparison analysis of these two filaments. The coronal magnetic field extrapolated using a CESE-MHD-NLFFF code (Jiang & Feng 2013) reveals that two magnetic flux ropes (MFRs) exist in the same extrapolation box supporting these two filaments, respectively. Analysis of the magnetic field shows that the eruptive MFR contains a bald-patch separatrix surface (BPSS) co-spatial very well with a pre-eruptive EUV sigmoid, which is consistent with the BPSS model for coronal sigmoids. The magnetic dips of the non-eruptive MFRs match Hα observation of the non-eruptive filament strikingly well, which strongly supports the MFR-dip model for filaments. Compared with the non-eruptive MFR/filament (with a length of about 200 Mm), the eruptive MFR/filament is much smaller (with a length of about 20 Mm), but it contains most of the magnetic free energy in the extrapolation box and holds a much higher free energy density than the non-eruptive one. Both the MFRs are weakly twisted and cannot trigger kink instability. The AR eruptive MFR is unstable because its axis reaches above a critical height for torus instability, at which the overlying closed arcades can no longer confine the MFR stably. On the contrary, the quiescent MFR is very firmly held by its overlying field, as its axis apex is far below the torus-instability threshold height. Overall, this comparison investigation supports that MFR can exist prior to eruption and the ideal MHD instability can trigger MFR eruption.
11 pages, 4 figures, accepted by RAA
References in corpus (17)
- Torus instability
- Ideal kink instability of a magnetic loop equilibrium
- Observation of An Evolving Magnetic Flux Rope Prior To and During A Solar Eruption
- Numerical simulations of fast and slow coronal mass ejections
- Slow Rise and Partial Eruption of a Double-Decker Filament. I Observations and Interpretation
- Observations and modeling of the early acceleration phase of erupting filaments involved in coronal mass ejections
- Prominence and Filament Eruptions Observed by the Solar Dynamics Observatory: Statistical Properties, Kinematics, and Online Catalog
- Catastrophe versus instability for the eruption of a toroidal solar magnetic flux rope
- A Chain of Winking (Oscillating) Filaments Triggered by an Invisible Extreme-Ultraviolet Wave
- Abrupt changes in photospheric magnetic and Lorentz-force vectors during neutral-line flares
- Multiwavelength observations of a partially eruptive filament on 2011 September 8
- Nonlinear Force-Free Field Extrapolation of a Coronal Magnetic Flux Rope Supporting a Large-Scale Filament from Photospheric Vector Magnetogram
- Direct Observations of Tether-cutting Reconnection During a Major Solar Event From 2014 February 24 to 25
- New Vacuum Solar Telescope observations of a flux rope tracked by a filament activation
- The Relationship between the Sudden Change of the Lorentz Force and the Magnitude of Associated Flares
- Three-dimensional Magnetic Restructuring in Two Homologous Solar Flares in the Seismically Active NOAA AR 11283
- Comparison of Emission Properties of two Homologous Flares in AR 11283
Cited by in corpus (4)
- Origin and Structures of Solar Eruptions I: Magnetic Flux Rope (Invited Review)
- On the Characteristics of Footpoints of Solar Magnetic Flux Ropes during the Eruption
- The eruption of a small-scale emerging flux rope as the driver of an M-class flare and a coronal mass ejection
- Formation and material supply of an active-region filament associated with newly emerging flux