paper

Twist Accumulation and Topology Structure of a Solar Magnetic Flux Rope

arXiv:1311.1883 · doi:10.1088/0004-637X/779/2/157

Abstract

To study the build up of a magnetic flux rope before a major flare and coronal mass ejection (CME), we compute the magnetic helicity injection, twist accumulation, and the topology structure of the three dimensional magnetic field, which is derived by the nonlinear force-free field model. The Extreme-ultraviolet Imaging Telescope on board the Solar and Heliospheric Observatory observed a series of confined flares without any CME before a major flare with a CME at 23:02 UT on 2005 January 15 in active region NOAA 10720. We derive the vector velocity at eight time points from 18:27 UT to 22:20 UT with the differential affine velocity estimator for vector magnetic fields, which were observed by the Digital Vector Magnetograph at Big Bear Solar Observatory. The injected magnetic helicity is computed with the vector magnetic and velocity fields. The helicity injection rate was (-16.47 \pm 3.52) \times 10^{40} Mx^2/hr. We find that only about 1.8% of the injected magnetic helicity became finally the internal helicity of the magnetic flux rope, whose twist increasing rate was -0.18 \pm 0.08 Turns/hr. The quasi-separatrix layers (QSLs) of the three dimensional magnetic field are computed by evaluating the squashing degree, Q. We find that the flux rope was wrapped by QSLs with large Q values, where the magnetic reconnection induced by the continuously injected magnetic helicity further produced the confined flares. We suggest that the flux rope was built up and heated by the magnetic reconnection in the QSLs.

32 pages, 9 figures, accepted for publication in ApJ

References in corpus (6)

Cited by in corpus (55)