The near-wall region of highly turbulent Taylor-Couette flow
arXiv:1501.03012 · doi:10.1017/jfm.2015.675
Abstract
Direct numerical simulations of the Taylor-Couette (TC) problem, the flow between two coaxial and independently rotating cylinders, have been performed. The study focuses on TC flow with mild curvature (small gap) with a radius ratio of , an aspect ratio of , and a stationary outer cylinder. Three inner cylinder Reynolds of , and were simulated, corresponding to frictional Reynolds numbers between and . An additional case with a large gap, and driving of was also performed. Small-gap TC was found to be dominated by spatially-fixed large-scale structures, known as Taylor rolls (TRs). TRs are attached to the boundary layer, and are active, i.e. they transport angular velocity through Reynolds stresses. An additional simulation with inner cylinder Reynolds number of and fixed outer cylinder with an externally imposed axial flow of comparable strength as the wind of the TRs was also conducted. The axial flow was found to convect the TRs without any weakening effect. For small-gap TC, evidence for the existence of logarithmic velocity fluctuations, and of an overlap layer, in which the velocity fluctuations collapse in outer units, was found. Profiles consistent with a logarithmic dependence were also found for the angular velocity in large-gap TC, albeit in a very reduced range of scales. Finally, the behaviour of both small- and large-gap TC was compared to other canonical flows. Small-gap TC has similar behaviour in the near-wall region to other canonical flows, while large-gap TC displays very different behaviour.
References in corpus (6)
- Direct numerical simulation of turbulent channel flow up to
- High Reynolds number Taylor-Couette turbulence
- Multiple states in highly turbulent Taylor-Couette flow
- Exploring the phase diagram of fully turbulent Taylor-Couette flow
- Effects of the computational domain size on direct numerical simulations of Taylor-Couette turbulence with stationary outer cylinder
- Effect of the number of vortices on the torque scaling in Taylor-Couette flow
Cited by in corpus (21)
- A FFT-based finite-difference solver for massively-parallel direct numerical simulations of turbulent flows
- AFiD-GPU: a versatile Navier-Stokes Solver for Wall-Bounded Turbulent Flows on GPU Clusters
- Effects of the computational domain size on direct numerical simulations of Taylor-Couette turbulence with stationary outer cylinder
- Wall roughness induces asymptotic ultimate turbulence
- GPU acceleration of CaNS for massively-parallel direct numerical simulations of canonical fluid flows
- Disentangling the origins of torque enhancement through wall roughness in Taylor-Couette turbulence
- The effect of roll number on the statistics of turbulent Taylor-Couette flow
- Direct numerical simulations of Taylor--Couette turbulence: the effect of sand grain roughness
- Taylor-Couette turbulence at radius ratio : scaling, flow structures and plumes
- Routes to turbulence in Taylor-Couette flow
- Dynamics and evolution of Turbulent Taylor rolls
- Characterizing the turbulent drag properties of rough surfaces with a Taylor--Couette setup
- Statistics, plumes and azimuthally traveling waves in ultimate Taylor-Couette turbulent vortices
- Turbulent Taylor-Couette flow with stationary inner cylinder
- Statistics of turbulence in the energy-containing range of Taylor-Couette compared to canonical wall-bounded flows
- Calculation of the mean velocity profile for strongly turbulent Taylor--Couette flow and arbitrary radius ratios
- Controlling secondary flows in Taylor-Couette flow using stress-free boundary conditions
- Exploring the origin of Turbulent Taylor rolls
- Taylor rolls on tour: Slow drift of turbulent large-scale structures in flows with continuous symmetries
- A low-communication-overhead parallel method for the 3D incompressible Navier-Stokes equations
- A FFT-accelerated multi-block finite-difference solver for massively parallel simulations of incompressible flows