Determination of total x-ray absorption coefficient using non-resonant x-ray emission
arXiv:1104.0259 · doi:10.1038/srep00182
Abstract
An alternative measure of x-ray absorption spectroscopy (XAS) called inverse partial fluorescence yield (IPFY) has recently been developed that is both bulk sensitive and free of saturation effects. Here we show that the angle dependence of IPFY can provide a measure directly proportional to the total x-ray absorption coefficient, . In contrast, fluorescence yield (FY) and electron yield (EY) spectra are offset and/or distorted from by an unknown and difficult to measure amount. Moreover, our measurement can determine in absolute units with no free parameters by scaling to at the non-resonant emission energy. We demonstrate this technique with measurements on NiO and NdGaO. Determining across edge-steps enables the use of XAS as a non-destructive measure of material composition. In NdGaO, we also demonstrate the utility of IPFY for insulating samples, where neither EY or FY provide reliable spectra due to sample charging and self-absorption effects, respectively.
arXiv comment17 pages, 5 figures
References in corpus (1)
Cited by in corpus (7)
- State-Dependent Electron Delocalization Dynamics at the Solute-Solvent Interface: Soft X-ray Absorption Spectroscopy and Ab Initio Calculations
- Hard x-ray emission spectroscopy: a powerful tool for the characterization of magnetic semiconductors
- Anomalous charge and negative-charge-transfer insulating state in cuprate chain-compound KCuO_2
- Utility of the inverse partial fluorescence for electronic structure studies of battery materials
- Evolution of the magnetic excitations in electron-doped
- Trigonal distortion in the Kitaev candidate honeycomb magnet BaCo2(AsO4)2
- Magnetic Ni-N-Ni Centers in N-substituted NiO